经峡部螺钉用于颈椎后路融合——基于CT多平面重建的新置钉轨迹研究(第一部分)
本研究基于10例患者80个C3-C6节段的重建颈椎CT,回顾性比较两种经峡部螺钉轨迹与标准侧块螺钉、颈椎椎弓根螺钉轨迹。轨迹B的峡部长度显著长于轨迹A(15.69±0.65 mm vs 12.51±0.24 mm,p<0.01),轨迹B与侧块螺钉长度相当,两种轨迹均提供安全角度范围。作者认为经峡部螺钉是侧块螺钉的可行替代,轨迹B尤其可行且安全,但临床应用前需生物力学验证。
要点
- 轨迹B峡部长度15.69±0.65 mm,显著长于轨迹A的12.51±0.24 mm(p<0.01)。
- 侧块螺钉长度与采用轨迹B的经峡部螺钉长度相当。
- 两种经峡部轨迹均提供安全角度范围,减少对椎动脉和脊髓损伤的风险。
核心结论
- 经峡部螺钉是颈椎后路融合中侧块螺钉的可行替代,尤其适用于微创脊柱手术(MISS)情境。
- 轨迹B是可行且安全的替代选择,可降低椎动脉和脊髓损伤风险。
- 临床应用前需进行生物力学验证。
研究设计与样本
- 回顾性分析10例患者的重建颈椎CT扫描,在80个C3-C6节段上进行峡部形态学测量。
- 评估两种经峡部螺钉轨迹:轨迹A(上外象限进钉、水平轨迹)和轨迹B(下外象限进钉、向头侧倾斜轨迹)。
- 与标准侧块螺钉和颈椎椎弓根螺钉轨迹比较,评估螺钉长度、角度及对椎管和横突孔的潜在风险。
主要发现
- 轨迹B的峡部长度(15.69±0.65 mm)显著长于轨迹A(12.51±0.24 mm;p<0.01)。
- 采用轨迹B的经峡部螺钉长度与侧块螺钉长度相当。
- 两种经峡部轨迹均提供安全角度范围,将对精细结构的风险降至最低。
临床怎么用
- 作者认为经峡部螺钉可作为颈椎后路融合中侧块螺钉的可行替代,尤其在MISS情境下。
- 作者认为轨迹B是可行且安全的替代选择,可降低椎动脉和脊髓损伤风险。
- 作者指出术前评估和术中技术对成功实施至关重要。
- 作者指出临床应用前需进行生物力学验证。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
BACKGROUND: Lateral mass screw fixation is the standard for posterior cervical fusion between C3 and C6. Traditional trajectories stabilize but carry risks, including nerve root and vertebral artery injuries. Minimally invasive spine surgery (MISS) is gaining popularity, but trajectories present anatomical challenges. RESEARCH QUESTION: This study proposes a novel pars interarticularis screw trajectory to address these issues and enhance in-line instrumentation with cervical pedicle screws. MATERIALS AND METHODS: A retrospective analysis of reformatted cervical CT scans included 10 patients. Measurements of the pars interarticularis morphology were performed on 80 segments (C3-C6). Two pars interarticularis screw trajectories were evaluated: Trajectory A (upper outer quadrant entry, horizontal trajectory) and Trajectory B (lower outer quadrant entry, cranially pointed trajectory). These were compared to standard lateral mass and cervical pedicle screw trajectories, assessing screw lengths, angles, and potential risks to the spinal canal and transverse foramen. RESULTS: Trajectory B showed significantly longer pars lengths (15.69 ± 0.65 mm) compared to Trajectory A (12.51 ± 0.24 mm; p < 0.01). Lateral mass screw lengths were comparable to pars interarticularis screw lengths using Trajectory B. Both trajectories provided safe angular ranges, minimizing the risk to delicate structures. DISCUSSION: and Conclusion. Pars interarticularis screws offer a viable alternative to lateral mass screws for posterior cervical fusion, especially in MISS contexts. Trajectory B, in particular, presents a feasible and safe alternative, reducing the risk of vertebral artery and spinal cord injury. Preoperative assessment and intraoperative technologies are essential for successful implementation. Biomechanical validation is needed before clinical application.
引用
- Lener S, Wipplinger C, Abramovic A, et al. Pars interarticularis screws for posterior cervical fusion - investigating a new trajectory using a CT-based multiplanar reconstruction: Part I. Acta Neurochir (Wien). 2024. PMID: 38990411. doi:10.1007/s00701-024-06184-x
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。