C1-2 超动度对脊髓的影响:有限元分析
作者用 Code_Aster 程序建立有限元模型,评估 C1-2 超动度对脊髓的机械影响,对骨、韧带、灰质和白质施加 Young 模量标准值。模型包括 C1 相对 C2 旋转 25° 与 50°、侧向平移 2.5 mm 与 5 mm,计算颈髓交界处最大 von Mises 应力(VMS)。结果显示病理旋转(50°)和侧向平移(5 mm)时脊髓应力显著,与严重脊髓压迫和脊髓病患者所见数值一致。
要点
- C1 相对 C2 侧向平移 2.5 mm 模型灰质最大 VMS 为 0.041 MPa、白质为 0.097 MPa。
- C1 相对 C2 侧向平移 5 mm 模型灰质最大 VMS 为 0.069 MPa、白质为 0.162 MPa。
- C1 相对 C2 旋转 50° 模型灰质最大 VMS 为 0.113 MPa、白质为 0.264 MPa,与严重脊髓压迫和脊髓病患者数值一致。
核心结论
- 有限元分析显示,病理旋转(50°)和侧向平移(5 mm)时脊髓应力显著,与严重脊髓压迫和脊髓病患者所见数值一致。
- 尽管有限元模型需要对寰枢关节进行过度简化,本研究提供生物力学证据表明 C1-2 关节内超动度导致病理性脊髓应力。
研究设计与样本
- 有限元分析(FEA),使用 Code_Aster 程序建立模型,对骨、韧带、灰质和白质施加 Young 模量标准值。
- 建立 C1 相对 C2 旋转 25° 与 50°、侧向平移 2.5 mm 与 5 mm 的模型,计算并分析颈髓交界处最大 von Mises 应力(VMS)。
主要发现
- C1 相对 C2 侧向平移 2.5 mm 模型:灰质最大 VMS 为 0.041 MPa,白质最大 VMS 为 0.097 MPa。
- C1 相对 C2 侧向平移 5 mm 模型:灰质最大 VMS 为 0.069 MPa,白质最大 VMS 为 0.162 MPa。
- C1 相对 C2 旋转 25° 模型:灰质最大 VMS 为 0.052 MPa,白质最大 VMS 为 0.123 MPa。
- C1 相对 C2 旋转 50° 模型:灰质最大 VMS 为 0.113 MPa,白质最大 VMS 为 0.264 MPa。
局限性
- 该有限元模型需要对寰枢关节进行过度简化。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
OBJECTIVE: The authors present a finite element analysis (FEA) evaluating the mechanical impact of C1-2 hypermobility on the spinal cord. METHODS: The Code_Aster program was used to perform an FEA to determine the mechanical impact of C1-2 hypermobility on the spinal cord. Normative values of Young's modulus were applied to the various components of the model, including bone, ligaments, and gray and white matter. Two models were created: 25° and 50° of C1-on-C2 rotation, and 2.5 and 5 mm of C1-on-C2 lateral translation. Maximum von Mises stress (VMS) throughout the cervicomedullary junction was calculated and analyzed. RESULTS: The FEA model of 2.5 mm lateral translation of C1 on C2 revealed maximum VMS for gray and white matter of 0.041 and 0.097 MPa, respectively. In the 5-mm translation model, the maximum VMS for gray and white matter was 0.069 and 0.162 MPa. The FEA model of 25° of C1-on-C2 rotation revealed maximum VMS for gray and white matter of 0.052 and 0.123 MPa. In the 50° rotation model, the maximum VMS for gray and white matter was 0.113 and 0.264 MPa. CONCLUSIONS: This FEA revealed significant spinal cord stress during pathological rotation (50°) and lateral translation (5 mm) consistent with values found during severe spinal cord compression and in patients with myelopathy. While this finite element model requires oversimplification of the atlantoaxial joint, the study provides biomechanical evidence that hypermobility within the C1-2 joint leads to pathological spinal cord stress.
引用
- Patel AA, Greenberg JK, Steinmetz MP, et al. C1-2 hypermobility and its impact on the spinal cord: a finite element analysis. J Neurosurg Spine. 2024. PMID: 38701531. doi:10.3171/2024.2.SPINE231327
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。