识别分枝杆菌测序项目中的混合结核感染与实验室交叉污染
该研究在英格兰公共卫生署国家分枝杆菌实验室建立基于NGS的方法,分析4,156份结核分枝杆菌阳性样本的MiSeq测序数据,通过比较两个最混合谱系定义位点集(F2)与47个最不混合位点集(F47)的非主要变异比例,识别实验室交叉污染和混合感染,并报告生产使用中三种模式的比例分别为97%、2.8%和0.001%。
要点
- F2与F47指标可区分多重谱系混合与两谱系混合。
- 高F47指标成批出现且与H37Rv对照相似时提示交叉污染。
- 生产使用中三种模式比例分别为97%、2.8%、0.001%。
核心结论
- 基于F2和F47指标的方法可用于检测结核分枝杆菌测序中的混合感染和实验室交叉污染。
研究设计与样本
- 研究在英格兰公共卫生署国家分枝杆菌实验室进行,对4,156份结核分枝杆菌阳性样本的663次MiSeq测序数据进行分析,并在流程开发阶段估计预期变异。
主要发现
- 观察到三种模式:两种指标均不混合、高F47指标提示多谱系混合、F2相对F47差异升高提示两谱系混合。
- 高F47模式成批出现,且与每批次中H37Rv对照的相似模式相关,可能反映交叉污染。
- 生产使用中三种模式的样本比例分别为97%、2.8%和0.001%。
关键数值与推荐
- 对每个样本在55组谱系定义位点上确定非主要变异比例。
- 比较两个最混合谱系定义位点集的非主要变异比例(F2指标)与47个最不混合位点集的非主要变异比例(F47指标)。
临床怎么用
- F2和F47指标可用于测序结核分枝杆菌基因组的实验室进行过程控制。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
The detection of laboratory cross-contamination and mixed tuberculosis infections is an important goal of clinical mycobacteriology laboratories. The objective of this study was to develop a method to detect mixtures of different Mycobacterium tuberculosis lineages in laboratories performing mycobacterial next-generation sequencing (NGS). The setting was the Public Health England National Mycobacteriology Laboratory Birmingham, which performs Illumina sequencing on DNA extracted from positive mycobacterial growth indicator tubes. We analyzed 4,156 samples yielding M. tuberculosis from 663 MiSeq runs, which were obtained during development and production use of a diagnostic process using NGS. The counts of the most common (major) variant and all other variants (nonmajor variants) were determined from reads mapping to positions defining M. tuberculosis lineages. Expected variation was estimated during process development. For each sample, we determined the nonmajor variant proportions at 55 sets of lineage-defining positions. The nonmajor variant proportion in the two most mixed lineage-defining sets (F2 metric) was compared with that of the 47 least-mixed lineage-defining sets (F47 metric). The following three patterns were observed: (i) not mixed by either metric; (ii) high F47 metric, suggesting mixtures of multiple lineages; and (iii) samples compatible with mixtures of two lineages, detected by differential F2 metric elevations relative to F47. Pattern ii was observed in batches, with similar patterns in the M. tuberculosis H37Rv control present in each run, and is likely to reflect cross-contamination. During production, the proportions of samples in the patterns were 97%, 2.8%, and 0.001%, respectively. The F2 and F47 metrics described could be used for laboratory process control in laboratories sequencing M. tuberculosis genomes.
引用
- Wyllie DH, Robinson E, Peto T, et al. Identifying Mixed Mycobacterium tuberculosis Infection and Laboratory Cross-Contamination during Mycobacterial Sequencing Programs. J Clin Microbiol. 2018. PMID: 30209183. doi:10.1128/JCM.00923-18
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。