文献速递分子诊断临床微生物

纳米孔测序在临床分离株质粒及耐药基因检测中的快速应用

Rapid Nanopore Sequencing of Plasmids and Resistance Gene Detection in Clinical Isolates.
PubMed 文献 · J Clin Microbiol · 2017-10-11

本研究评估了Oxford Nanopore Technologies MinION台式长读长测序在临床微生物实验室中的工作流程和周转时间,对三株临床分离株进行基因组和质粒测序,并与Illumina MiSeq比较。使用质粒DNA测序可在低至2,000至5,000条reads(20分钟测序)内获得足以完整注释耐药基因的组装,仅用MinION的工作流程可在6小时内完成质粒耐药基因内容注释,快于传统表型药敏试验。

要点

  • MinION仅用质粒DNA测序可在20分钟测序(2,000-5,000 reads)内获得足以完整注释耐药基因的组装。
  • MinION-only工作流程可在6小时内完成质粒耐药基因内容注释,快于传统表型药敏试验。
  • 对参考肺炎克雷伯菌分离株的三个质粒,MinION-only组装准确率约99%,经MiSeq reads抛光后准确率>99.9%。

核心结论

  • MinION台式长读长测序结合质粒DNA测序可实现临床分离株耐药基因的快速检测,周转时间短于传统表型药敏试验。

研究设计与样本

  • 研究评估了Oxford Nanopore Technologies MinION测序仪在临床微生物实验室中的工作流程和周转时间。
  • 对三株临床分离株进行基因组和质粒测序,同时使用MinION和Illumina MiSeq,采用不同文库制备方法(2D和快速1D)。
  • 重新测序了参考肺炎克雷伯菌分离株的三个质粒,并测序了先前未表征的产ESBL大肠埃希菌和肺炎克雷伯菌临床分离株的质粒DNA。

主要发现

  • 参考肺炎克雷伯菌分离株的三个质粒重新测序显示,MinION-only草图组装准确率约99%,经MiSeq reads抛光后组装准确率>99.9%。
  • 使用MinION对产ESBL大肠埃希菌和肺炎克雷伯菌临床分离株进行质粒DNA测序,在草图组装中成功鉴定出与所有观察到的质粒介导表型耐药类别对应的耐药基因。
  • 使用质粒DNA可实现更低深度测序,仅需2,000至5,000条reads(可在20分钟测序内获得)即可获得足以完整注释耐药基因的组装。
  • 仅用MinION的工作流程可在6小时内从传代培养的分离株获得质粒耐药基因内容的完整注释,快于传统表型药敏试验。

关键数值与推荐

  • MinION-only草图组装对参考肺炎克雷伯菌分离株三个质粒的准确率约99%。
  • 经MiSeq reads抛光后组装准确率>99.9%。
  • 质粒DNA测序仅需2,000至5,000条reads即可获得足以完整注释耐药基因的组装,该reads数可在20分钟测序内获得。
  • 仅用MinION的工作流程可在6小时内从传代培养的分离株获得质粒耐药基因内容的完整注释。

临床怎么用

  • 在临床微生物实验室中,可采用MinION台式长读长测序结合质粒DNA测序快速检测临床分离株的耐药基因,缩短报告时间。
  • 对于需要快速获取耐药基因信息的场景,可优先考虑MinION-only工作流程,其周转时间短于传统表型药敏试验。
  • 若需提高组装准确率,可补充MiSeq reads进行抛光。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

Recent advances in nanopore sequencing technology have led to a substantial increase in throughput and sequence quality. Together, these improvements may permit real-time benchtop genomic sequencing and antimicrobial resistance gene detection in clinical isolates. In this study, we evaluated workflows and turnaround times for a benchtop long-read sequencing approach in the clinical microbiology laboratory using the Oxford Nanopore Technologies MinION sequencer. We performed genomic and plasmid sequencing of three clinical isolates with both MinION and Illumina MiSeq, using different library preparation methods (2D and rapid 1D) with the goal of antimicrobial resistance gene detection. We specifically evaluated the advantages of using plasmid DNA for sequencing and the value of supplementing MinION sequences with MiSeq reads for increasing assembly accuracy. Resequencing of three plasmids in a reference Klebsiella pneumoniae isolate demonstrated ∼99% accuracy of draft MinION-only assembly and >99.9% accuracy of assembly polished with MiSeq reads. Plasmid DNA sequencing of previously uncharacterized clinical extended-spectrum β-lactamase (ESBL)-producing Escherichia coli and K. pneumoniae isolates using MinION allowed successful identification of antimicrobial resistance genes in the draft assembly corresponding to all classes of observed plasmid-based phenotypic resistance. Importantly, use of plasmid DNA enabled lower depth sequencing, and assemblies sufficient for full antimicrobial resistance gene annotation were obtained with as few as 2,000 to 5,000 reads, which could be acquired in 20 min of sequencing. With a MinION-only workflow that balances accuracy against turnaround time, full annotation of plasmid resistance gene content could be obtained in under 6 h from a subcultured isolate, less time than traditional phenotypic susceptibility testing.

来源:J Clin Microbiol,查看原文。版权归原作者所有。

引用

  1. Lemon JK, Khil PP, Frank KM, et al. Rapid Nanopore Sequencing of Plasmids and Resistance Gene Detection in Clinical Isolates. J Clin Microbiol. 2017. PMID: 29021151. doi:10.1128/JCM.01069-17

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。