全自动微生物实验室优化培养读取时间
该研究评估Copan WaspLab自动化系统下提前读取培养对鉴定与药敏准确性的影响。374份标本培养显示非尿液标本16小时超50%可处理、36小时全部可处理,尿液90%在16小时可处理。冷冻菌株在10和16小时MALDI-TOF鉴定准确率仍高,多数药物药敏 essential agreement 超90%。
要点
- 非尿液标本16小时超50%可处理,36小时100%可处理;尿液90%在16小时可处理。
- 革兰阴性菌10小时鉴定准确率98.8%,16小时97.6%;革兰阳性菌分别为97.6%和98.4%。
- 酵母菌10小时鉴定准确率91.6%,16小时100%。
核心结论
- 自动化微生物实验室可在16小时提前读取培养,不损害鉴定和药敏准确性。
研究设计与样本
- 374份患者标本同时用传统孵育和MLA培养,MLA图像采集10至72小时。
- 另用冷冻菌株127株革兰阳性菌、83株革兰阴性菌和12株酵母评估10和16小时鉴定与药敏准确性。
主要发现
- 非尿液标本16小时超50%可处理,24小时92%,36小时100%;尿液90%在16小时可处理。
- 革兰阴性菌鉴定准确率10小时98.8%、16小时97.6%;革兰阳性菌10小时97.6%、16小时98.4%;酵母10小时91.6%、16小时100%。
- Vitek 2 GN-807N、GP75和ST02卡上多数药物10和16小时药敏 essential agreement 超90%。
- 特定药物如头孢唑林、哌拉西林/他唑巴坦、呋喃妥因和利奈唑胺错误率升高。
关键数值与推荐
- 非尿液标本16小时超50%可处理,24小时92%,36小时100%。
- 尿液培养90%在16小时可处理。
- 革兰阴性菌鉴定准确率10小时98.8%、16小时97.6%。
- 革兰阳性菌鉴定准确率10小时97.6%、16小时98.4%。
- 酵母菌鉴定准确率10小时91.6%、16小时100%。
临床怎么用
- 可考虑在MLA工作流中采用16小时读取培养,以加速鉴定和药敏报告。
- 对头孢唑林、哌拉西林/他唑巴坦、呋喃妥因和利奈唑胺需注意错误率升高。
局限性
- 特定药物错误率升高与敏感菌株数量有限和折点相关挑战有关。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
UNLABELLED: Clinical microbiology laboratories are increasingly adopting automation to meet testing demands, improve throughput, and accelerate diagnostic turnaround. This study evaluated optimal culture read times using Copan WaspLab microbiology laboratory automation (MLA) to determine if earlier read times affect accuracy and turnaround times as they pertain to microbial identification and antimicrobial susceptibility testing (AST). A total of 374 patient specimens were cultured simultaneously using a conventional incubation method and MLA, with MLA images captured from 10 to 72 h of incubation. Non-urine specimens were ready for workup in over 50% of cases at 16 h, 92% by 24 h, and 100% by 36 h, while 90% of urine cultures were ready for workup by 16 h. Using frozen isolates (127 gram-positive bacteria, 83 gram-negative bacteria, and 12 yeasts), we further evaluated the accuracy of MALDI-TOF identification and AST results for cultures incubated for 10 h and 16 h in MLA. Identification accuracy remained high across all groups, with gram-negative bacteria achieving 98.8% accuracy at 10 h and 97.6% at 16 h, gram-positive bacteria showing 97.6% accuracy at 10 h and 98.4% at 16 h, and yeasts demonstrating 91.6% accuracy at 10 h and 100% at 16 h of incubation, respectively. AST results using cultures at both time points demonstrated essential agreement above 90% for most drugs on Vitek 2 GN-807N, GP75, and ST02 AST cards. Minor and major errors were rare; however, elevated error rates were observed for specific drugs (e.g., cefazolin, piperacillin/tazobactam, nitrofurantoin, and linezolid), largely due to a limited number of susceptible isolates and breakpoint-related challenges. MLA enables earlier culture reads while maintaining ID and AST accuracy. IMPORTANCE: Microbiology laboratory automation (MLA) is increasingly used to address rising test volumes and workforce limitations; however, optimal incubation durations for automated workflows are not well defined. In this study, we demonstrate that cultures from a range of specimen types can be reliably read as early as 16 h and finalized by 36 h without compromising organism identification or antimicrobial susceptibility testing accuracy compared to conventional incubation. These findings support the use of earlier culture read time points in MLA workflows, enabling faster turnaround of clinically actionable results. Implementation of optimized incubation times has the potential to improve laboratory efficiency and accelerate patient care decisions while maintaining diagnostic reliability.
引用
- Glover JS, Demarest BB, Foster PJ, et al. Optimization of culture read times using full microbiology laboratory automation. J Clin Microbiol. 2026. PMID: 42757838. doi:10.1128/jcm.00232-26
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。