文献速递临床生化质量管理与危急值

全实验室自动化中自动存储检索模块的临床生化样本稳定性

Total lab automation: sample stability of clinical chemistry parameters in an automated storage and retrieval module.
PubMed 文献 · Clin Chem Lab Med · 2021-11-02

研究评估了全实验室自动化系统中自动存储检索模块内血清和肝素血浆样本28项生化指标的稳定性,发现72小时内9项指标超出理想偏差标准,其中肝素血浆中磷、钾、乳酸脱氢酶和葡萄糖的稳定时间分别仅为24、12、4和8小时,碳酸氢盐不应作为追加检测。总体而言,该模块对常规生化指标稳定性的影响与手动存储相当。

要点

  • 肝素血浆中磷、钾、LDH和葡萄糖稳定性分别仅为24、12、4和8小时。
  • 血清中电解质和LDH活性在48小时后显著升高。
  • 碳酸氢盐不宜作为追加检测项目。

核心结论

  • 自动存储检索模块内的条件对样本稳定性无临床影响,常规生化指标在72小时内可稳定测量,与手动存储设施相当。

研究设计与样本

  • 使用57份新鲜常规血清样本和42份锂肝素血浆样本,基线测量后于2-8°C自动存储检索模块中储存,在2、4、8、12、24、48和72小时固定时间点于Abbott Architect c16000上复测,以相对于基线的百分比差异表示浓度,并与生物学变异数据库的理想偏差标准比较。

主要发现

  • 28项常见生化指标中,9项在72小时内(血清、血浆或两者)超出偏差标准。
  • 锂肝素血浆中磷、钾和乳酸脱氢酶(LDH)值升高,仅分别被认为稳定24、12和4小时,葡萄糖稳定8小时。
  • 血清中电解质浓度和LDH活性在48小时后显著升高。

关键数值与推荐

  • 肝素血浆中磷稳定24小时、钾稳定12小时、LDH稳定4小时、葡萄糖稳定8小时。
  • 血清中电解质和LDH活性在48小时后显著升高。
  • 碳酸氢盐不应作为追加检测进行。

临床怎么用

  • 基于自动存储检索模块的常规生化检测可在72小时内完成,但需注意肝素血浆中磷、钾、LDH和葡萄糖的较短稳定时间,碳酸氢盐不宜作为追加检测。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

OBJECTIVES: Automated storage and retrieval modules (SRM), as part of total lab automation (TLA) systems, offer tremendous practical and economic benefits. In contrast to manual storage systems, SRMs indicate continuous motion of samples and may leave samples prone to temperature fluctuations. This study investigates analyte stability in serum and heparin plasma within an automated storage module. METHODS: The stability of 28 common biochemistry analytes was investigated using 57 freshly obtained routine serum samples and 42 lithium-heparin plasma samples. Following baseline measurement, samples were stored at 2-8 °C in the automated SRM of the Accelerator a3600 TLA and reanalyzed at fixed time points (2, 4, 8, 12, 24, 48 and 72 h) on the Abbott Architect c16000 chemistry analyzer. The concentration at each time point was expressed as %-difference to the baseline value and mean results were compared to the criteria for desirable bias derived from the biological variation database. RESULTS: Nine of the analytes exceeded the bias criterion within 72 h after initial measurement in either serum samples, plasma samples or both. Lithium-heparin plasma samples showed increasing values for phosphor, potassium and lactate dehydrogenase (LDH), which were only considered stable for respectively 24, 12 and 4 h, glucose was considered stable for 8 h. Electrolyte concentrations and LDH activity significantly increased in serum samples beyond 48 h. Bicarbonate should not be performed as add-on test at all. CONCLUSIONS: The presented data indicate that the conditions within an SRM have no clinical impact on sample stability and allow stable measurement of routine analytes within 72 h, comparable to manual storage facilities.

来源:Clin Chem Lab Med,查看原文。版权归原作者所有。

引用

  1. Vercruysse K, Lambrecht S, Oyaert M, et al. Total lab automation: sample stability of clinical chemistry parameters in an automated storage and retrieval module. Clin Chem Lab Med. 2021. PMID: 34726358. doi:10.1515/cclm-2021-0866

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。