Copan WASPLab自动化显著缩短培养孵育时间并允许更早判读
该研究比较WASPLab自动化(接种与自动孵育结合定时高分辨率数字成像)与WASP自动化接种联合传统孵育及手工诊断,对1294份临床样本(包括尿液、生殖道、非无菌部位及ESwabs筛查MRSA、MSSA、ESBL、CPE)进行检测。结果显示WASPLab在18小时对MRSA/MSSA、16小时对ESBL/CPE的检测灵敏度均为100%,且对尿液标本18小时与24小时培养相似度为79%,生殖道和非无菌部位标本分别定义28小时为最终孵育时间。结论认为WASPLab可在不影响性能的前提下缩短所有测试标本的培养判读时间。
要点
- WASPLab自动化可缩短培养判读时间且不影响检测性能。
- MRSA/MSSA在18小时、ESBL/CPE在16小时的检测灵敏度均为100%。
- 生殖道和非无菌部位标本的最终孵育时间定义为28小时。
核心结论
- WASPLab自动化能够在不影响性能的情况下缩短所有测试标本的培养判读时间。
研究设计与样本
- 比较WASPLab自动化与传统方法的前瞻性研究,共纳入1294份临床样本,包括483份推导集和811份独立验证集。
主要发现
- WASPLab在18小时对MRSA和MSSA的检测灵敏度为100%(95%CI 94.48-100.00%)。
- WASPLab在16小时对ESBL和CPE的检测灵敏度为100%(95%CI 94.87-100.00%)。
- 尿液标本在WASPLab上18小时与24小时培养的相似度为79%(295/375)。
- 生殖道标本在WASPLab上16小时与28小时培养的相似度为26%(72/281)。
- 非无菌部位标本在WASPLab上16小时与28小时培养的相似度为77%(123/159)。
关键数值与推荐
- MRSA和MSSA在WASPLab上18小时的检测灵敏度为100%(95%CI 94.48-100.00%)。
- ESBL和CPE在WASPLab上16小时的检测灵敏度为100%(95%CI 94.87-100.00%)。
- 尿液标本在WASPLab上18小时与24小时培养的相似度为79%(295/375)。
- 生殖道标本在WASPLab上16小时与28小时培养的相似度为26%(72/281)。
- 非无菌部位标本在WASPLab上16小时与28小时培养的相似度为77%(123/159)。
临床怎么用
- 实施经过验证的孵育时间可构建适当的实验室工作流程以提高效率。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
OBJECTIVE: The aim was to evaluate whether laboratory automation (inoculation and automated incubation combined with timely defined high-resolution digital imaging) may help reduce the time required to obtain reliable culture analysis results. METHODS: We compared the results obtained by WASPLab automation against WASP-based automated inoculation coupled to conventional incubation and manual diagnostic on 1294 clinical samples (483 for the derivation set and 811 for the independent validation set) that included urine, genital tract and non-sterile site specimens, as well as ESwabs for screening of methicillin-resistant Staphylococcus aureus (MRSA), methicillin-sensitive Staphylococcus aureus (MSSA), extended-spectrum beta-lactamases (ESBLs) and carbapenemase-producing Enterobacteriaceae (CPE). We used sequential routine specimens referred to the bacteriology laboratory at Geneva University Hospitals between October 2018 and March 2019. RESULTS: The detection sensitivity of MRSA and MSSA at 18 hr on WASPLab was 100% (95% confidence interval [CI], 94.48-100.00%). The detection sensitivity of ESBL and CPE at 16 hr on WASPLab was 100% (95% confidence interval [CI], 94.87% to 100.00%). For urine specimens, the similarity was 79% (295/375) between 18 hr and 24 hr of incubation on WASPLab. For genital tract and non-sterile site specimens, the similarity between 16 hr and 28 hr of incubation on WASPLab were 26% (72/281) and 77% (123/159) respectively. Thus, 28 hr was defined as the final incubation time on WASPLab for genital tract and non-sterile site specimens. CONCLUSIONS: The results of this study show that WASPLab automation enables a reduction of the culture reading time for all specimens tested without affecting performances. Implementing the established and duly validated incubation times will allow appropriate laboratory workflows for improved efficiency to be built.
引用
- Cherkaoui A, Renzi G, Vuilleumier N, et al. Copan WASPLab automation significantly reduces incubation times and allows earlier culture readings. Clin Microbiol Infect. 2019. PMID: 30986560. doi:10.1016/j.cmi.2019.04.001
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。