文献速递疝与腹壁外科围术期管理与 ERAS

手持全关节软件驱动腹腔镜持针器在TAPP疝修补术中的初步经验

Initial experience using a handheld fully articulating software-driven laparoscopic needle driver in TAPP inguinal hernia repair.
PubMed 文献 · Surg Endosc · 2021-04-06

单术者连续TAPP病例视频对比研究,比较关节持针器与直杆腹腔镜在补片固定和腹膜缝合的时间,并分析学习曲线与成本。关节器械缝合腹膜每针时间从初始10例的60.61秒降至38.84秒(P=0.0004),与标准腹腔镜相当;缝合补片固定比 tacker 更经济。

要点

  • 关节持针器缝合腹膜每针时间经10例学习后与标准腹腔镜相当。
  • 补片固定用tacker平均227秒,关节器械462.4秒(P=0.06)。
  • 缝合补片固定比tacker固定更具成本效益。

核心结论

  • 经过仅10例初始经验,手持关节持针器在TAPP补片缝合固定和腹膜关闭中与标准腹腔镜相当。
  • 缝合补片固定可减少对昂贵tacker设备的依赖。

研究设计与样本

  • 单术者连续TAPP病例视频回顾对比,关节器械组与直杆腹腔镜组比较。
  • 分析补片固定和腹膜缝合关闭两个关键步骤时间,并比较初始10例前后变化。
  • 同时进行两种技术的成本分析。

主要发现

  • 补片固定:tacker平均227秒,关节器械462.4秒(p=0.06)。
  • 腹膜缝合每针时间从初始10例的60.61秒改善至之后的38.84秒(p=0.0004)。
  • 关节器械缝合腹膜每针时间与标准腹腔镜相当(34.8秒 vs 34.84秒,p=0.997)。
  • 初始10例后,左侧疝腹膜缝合每针时间显著长于右侧(左40.62秒 vs 右27.91秒,p=0.005)。
  • 直接成本分析显示关节器械缝合腹膜比tacker固定更具成本效益。

临床怎么用

  • TAPP术中可考虑使用手持关节持针器完成补片缝合固定和腹膜关闭。
  • 术者需经约10例学习曲线后缝合时间可达到与标准腹腔镜相当。
  • 左侧疝修补时腹膜缝合可能需更多时间,应预留相应操作时间。

局限性

  • 单术者连续病例视频回顾性对比,样本量未报告。
  • 补片固定时间比较的p=0.06未达统计学显著。
  • 成本分析仅报告直接成本比较方向,未提供具体数值。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: The laparoscopic transabdominal preperitoneal (TAPP) inguinal hernia repair is a widely performed minimally invasive operation, but can present considerable ergonomic challenges for the surgeon. Our objective was to determine if a novel handheld software-driven laparoscopic articulating needle driver can mitigate these difficulties. METHODS: The video recordings of a consecutive series of TAPP cases by a single surgeon using the articulating device were compared with a series of cases using straight-stick laparoscopy. Two critical steps of the procedure were analyzed for time: mesh fixation and peritoneal suture closure. These steps were then compared before and after 10 initial consecutive cases to analyze whether the surgeon demonstrated improvement. A cost analysis was also performed between the two techniques. RESULTS: For mesh fixation, the surgeon averaged 227 s using tacker devices, compared with 462.4 s using the novel laparoscopic device (p = 0.06). For the peritoneal closure component of the operation, the surgeon improved the time per suture pass during closure from 60.61 s during the first 10 cases to 38.84 s after the first 10 cases (p = 0.0004), which was comparable to the time per stitch for standard laparoscopy (34.8 s vs 34.84 s, p = 0.997). Left-sided inguinal hernia repairs using the articulating device demonstrated a significantly longer time per stitch during peritoneal closure compared to the right side after first 10 cases (left: 40.62 s; right: 27.91, p = 0.005). Our direct cost analysis demonstrated that suture closure of the peritoneum using the articulating device was more cost-effective than tack fixation. CONCLUSIONS: After only a 10 case initial experience, a laparoscopic hand-held articulating needle driver is comparable to standard laparoscopy to complete suture mesh fixation and peritoneal closure for TAPP inguinal hernia repair. Further, the feasibility of suture mesh fixation minimizes the need for costly tacker devices. This instrument appears to be a promising tool in this largely minimally invasive era of hernia repair.

来源:Surg Endosc,查看原文。版权归原作者所有。

引用

  1. Needham V, Camacho D, Malcher F, et al. Initial experience using a handheld fully articulating software-driven laparoscopic needle driver in TAPP inguinal hernia repair. Surg Endosc. 2021. PMID: 33825010. doi:10.1007/s00464-021-08446-6

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。