文献速递牙体牙髓病

牙髓治疗运动学对根管治疗中应力分布的影响:光弹性应力分析

Impact of Endodontic Kinematics on Stress Distribution During Root Canal Treatment: Analysis of Photoelastic Stress.
PubMed 文献 · J Endod · 2021-10-23

结果显示所有系统均导致应力积累,定量分析组间无统计学显著差异(P > .05),定性分析中GPT和GTF应力水平高于GWO和GOS。应力在预备初期集中于冠部,末期集中于根中及根尖部。

要点

  • 所有镍钛系统在根管预备中均产生应力积累,应重视结构损伤风险。
  • 定量应力值组间无显著差异,但定性上GPT和GTF应力更高。
  • 应力分布随预备进程变化:初期冠部集中,末期根中及根尖集中。

核心结论

  • 所有牙髓治疗系统均导致牙体结构应力积累,且应力在牙齿不同部位和不同水平呈不同浓度分布。

研究设计与样本

  • 制备硅胶模具(2×15 mm),根管内使用pinjets固定牙齿,灌注光弹性树脂(2:1比例)形成模型。
  • 采用透射偏光镜分析四个牙区(牙冠区、根颈三分之一、根中三分之一、根尖三分之一),使用Tardy法量化条纹级数并计算最大应力值。
  • 数据采用双因素方差分析、Tukey检验(P < .05)及条纹描述性分析。

主要发现

  • 所有组在根管生物力学预备过程中产生的应力水平均显著增加。
  • 定量分析显示各组间无统计学显著差异(P > .05)。
  • 定性分析中,GPT和GTF器械产生的应力水平高于GWO和GOS器械。
  • 预备初期应力集中于牙冠水平,预备结束时应力集中于根中及根尖水平。

关键数值与推荐

  • 定量分析组间比较P > .05,无统计学显著差异。
  • 定性分析中GPT和GTF应力水平高于GWO和GOS。
  • 应力分布:初期冠部集中,末期根中及根尖集中。

临床怎么用

  • 临床选择镍钛器械时需考虑其应力分布特征,GPT和GTF可能产生更高应力。
  • 预备过程中应注意冠部和根尖区的应力积累,防范结构缺陷。

局限性

  • 样本量较小(每组n=6),可能影响统计效能。
  • 光弹性模型为体外研究,不能完全代表临床实际情况。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

INTRODUCTION: Structural defects created by endodontic treatment are the most common cause of major dental failures. This study analyzed levels of stress produced by endodontic instruments during the root canal treatment by photoelastic analysis of stress. METHODS: Twenty-four human premolars were randomly divided into 4 groups (n = 6) according to instrumentation protocol: ProTaper Next (GPT), One Shape (GOS), Wave One Gold (GWO), and TF Adaptive (GTF). The evaluation of the photoelastic model was performed at 4 dental zones: dental-crown region, cervical third of root, middle third of root, and apical third of root. Silicone molds were prepared (2 × 15 mm), and pinjets were used inside the root canals to fixate teeth. Photoelastic resin (2:1 ratio) was poured into the silicone molds to form photoelastic models. A transmission polariscope was used to analyze the positions of interest and recorded with a digital camera. Tardy's method was used to quantify the fringe order (n) and calculate the maximum stress value (τ) at each selected point. Data were analyzed with two-way analysis of variance, Tukey test (P < .05), fringe descriptive analysis. RESULTS: All groups showed a significant increase in the level of stress created during biomechanical preparation of the root canals. In the quantitative analysis, there was no statistically significant difference among the groups (P > .05). In the qualitative analysis, GPT and GTF instruments achieved greater levels of stresses compared with GWO and GOS instruments. At the beginning of instrumentation, stresses were concentrated at the coronary level and the end of instrumentation at the middle and apical root level. CONCLUSIONS: All endodontic systems resulted in accumulation of stress along the dental structure. Stress was found in different concentrations along the tooth and at different levels.

来源:J Endod,查看原文。版权归原作者所有。

引用

  1. Yamakami SA, Gallas JA, Petean IBF, et al. Impact of Endodontic Kinematics on Stress Distribution During Root Canal Treatment: Analysis of Photoelastic Stress. J Endod. 2021. PMID: 34699903. doi:10.1016/j.joen.2021.10.003

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。