根管锥度与开髓洞型设计对下颌磨牙牙髓治疗后寿命的有限元分析
本研究用有限元法模拟下颌第一磨牙,比较3种开髓洞型(传统、保守、桁架)与不同根管锥度(25/.04、25/.06、TruNatomy Prime、ProTaper Gold F2)对牙寿命的影响。结果显示开髓洞型对寿命影响大于根管锥度,传统开髓洞型寿命较低。
要点
- 开髓洞型设计比根管预备锥度更显著影响牙寿命。
- 传统开髓洞型寿命低于保守和桁架开髓洞型。
- 应力沿根面根向迁移,而非集中于颈周区。
核心结论
- 牙寿命受开髓洞型设计的影响比根管预备锥度更显著。
- 应力模式向根尖迁移而非集中于颈周区,裂纹可能发生在根面任何位置。
研究设计与样本
- 采用有限元分析对模拟下颌第一磨牙模型进行研究。
- 模型包含3种开髓洞型(传统、保守、桁架)。
- 近中根管预备为恒定锥度25/.04、25/.06或对应TruNatomy Prime和ProTaper Gold F2的变锥度。
- 所有模型远中根管预备为40/.04。
- 使用咬合指纹分析进行循环咬合加载直至模型失效。
主要发现
- 无论根管锥度如何,传统开髓洞型模型的寿命均低于保守和桁架开髓洞型模型。
- 保守与桁架开髓洞型模型之间寿命无显著差异。
- 应力沿根面根向迁移,尤其在近中根近中面和根分叉区外表面明显。
- 不同锥度根管预备后,根面应力分布模式和大小无显著变化。
临床怎么用
- 临床选择开髓洞型时应优先考虑保守或桁架设计以延长牙寿命。
- 根管预备锥度对牙寿命的影响相对较小。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
INTRODUCTION: This study investigated the impact of different canal tapers and access cavity designs on the life span of endodontically treated mandibular first molars using the finite element method. METHODS: Finite element analysis was performed on simulated models with 3 access cavity designs (traditional, conservative, and truss). The mesial canals were prepared to either constant tapers of 25/.04 and 25/.06 or a variable taper corresponding to the cumulative canal preparation shapes of TruNatomy Prime (Dentsply Sirona, Charlotte, NC) and ProTaper Gold F2 (Dentsply Sirona). The distal canals in all models had a 40/.04 preparation. Using occlusal fingerprint analysis, all models were subjected to cyclic occlusal loading until model failure. The number of cycles until failure, the location of failure, stress distribution patterns, and the maximum von Mises stresses were assessed. RESULTS: The traditional access models showed a lower life span than the conservative and truss models regardless of the canal taper, whereas there was not a notable difference in the conservative and truss models. The stresses migrated apically along the root surface and remarkably on the mesial aspect of the mesial root and the furcation area's outer surface. After root canal preparation with different tapers, there were no evident changes in the pattern and magnitude of the stresses distributed along the root surface. CONCLUSIONS: The life span of the tooth is affected more significantly by the access cavity design than the root canal preparation taper. Because stress patterns migrate apically rather than concentrate in the pericervical area, crack initiation and propagation might occur anywhere on the root surface.
引用
- Elkholy MMA, Nawar NN, Ha WN, et al. Impact of Canal Taper and Access Cavity Design on the Life Span of an Endodontically Treated Mandibular Molar: A Finite Element Analysis. J Endod. 2021. PMID: 34139264. doi:10.1016/j.joen.2021.06.009
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。