渐进式与微创根管预备对下颌磨牙抗折性的三维有限元分析
本研究通过三维有限元分析比较两种不同锥度锉系统预备下颌磨牙后的剩余牙体强度和应力分布。一颗牙用ProTaper Gold预备,另一颗用V-Taper 2H预备,均施加200-N多点模拟咀嚼负荷。结果显示ProTaper Gold预备模型的最大von Mises应力更高,V-Taper 2H预备保留更多颈周牙本质,可能增加抗折性。
要点
- ProTaper Gold预备后牙体最大应力高于V-Taper 2H预备。
- 两种模型最大形变均位于临床冠颊侧。
- 应力最高区在颈周牙本质,向根尖递减。
核心结论
- ProTaper Gold预备的牙体最大应力值高于V-Taper 2H预备的牙体。
- V-Taper 2H预备保留更多颈周牙本质,可能提高抗折性。
研究设计与样本
- 采用三维有限元分析比较两种锉系统预备下颌磨牙后的应力分布与形变。
- 使用两颗经模拟根管治疗的下颌磨牙TruTeeth模型,分别以ProTaper Gold和V-Taper 2H预备。
- 对两颗牙进行微计算机断层扫描并构建立体光刻表面网格用于有限元分析。
- 每个模型施加200-N多点载荷模拟咀嚼。
主要发现
- ProTaper Gold预备模型的最大von Mises应力大于V-Taper 2H预备模型。
- 两模型中总形变值均在临床冠颊侧最高。
- 最高应力值位于颈周牙本质,并向根尖方向递减。
临床怎么用
- 在需保留颈周牙本质以降低折裂风险时,可考虑使用V-Taper 2H等渐进式预备系统。
局限性
- 结论受本研究局限性约束。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
INTRODUCTION: This study compared the residual tooth strength and stress distribution of a mandibular molar prepared with different variable tapered file systems using finite element analysis (FEA). METHODS: Two preaccessed mandibular molar TruTeeth (Endo 3DP; Acadental, Lenexa, KS) were subjected to simulated endodontic treatment in this study. One tooth was instrumented with ProTaper Gold (Dentsply Tulsa Dental Specialties, Tulsa, OK), and the other was instrumented with V-Taper 2H (SS White Dental, Lakewood, NJ). The 2 teeth were scanned using micro-computed tomographic imaging, and stereolithographic surface meshes were developed for FEA. Each model was subjected to a 200-N multipoint load-simulating mastication. The results of the FEA provided quantitative and qualitative measurements for von Mises stress distribution and total deformation. RESULTS: The maximum von Mises stress was greater in the ProTaper Gold-prepared model than the V-Taper 2H prepared model. In both models, total deformation values were highest in the clinical crown on the buccal aspect of the tooth. The highest stress values were found in the pericervical dentin, and stress decreased apically through the root. CONCLUSIONS: Within the limitations of this study, it can be concluded that the maximum stress values within the tooth prepared by ProTaper Gold were higher than those in the tooth prepared by V-Taper 2H. Canal preparation with the V-Taper 2H system preserves more pericervical dentin, which may increase the resistance to fracture.
引用
- Smoljan M, Hussein MO, Guentsch A, et al. Influence of Progressive Versus Minimal Canal Preparations on the Fracture Resistance of Mandibular Molars: A 3-Dimensional Finite Element Analysis. J Endod. 2021. PMID: 33774046. doi:10.1016/j.joen.2021.03.008
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。