锥形流体微通道促进GelMA水凝胶内血管生成出芽的制备研究
本研究在GelMA水凝胶(5%、7.5%、10% w/v)中制作不同锥度(平行、0.04、0.06)的流体微通道,接种HUVECs-GFP单独或与SCAP共培养,评估血管生成出芽。结果发现1:1共培养、0.04锥度、5% GelMA且封装SCAP为促进微通道内血管生成的最佳条件。
要点
- SCAP与HUVEC-GFP以1:1比例共培养产生最长出芽。
- 0.04锥度微通道内出芽长度显著长于平行和0.06锥度。
- 5% GelMA水凝胶中HUVEC-GFP出芽差异显著,封装SCAP进一步刺激出芽。
核心结论
- SCAP与HUVEC-GFP以1:1比例在0.04锥度微通道、5% GelMA且封装SCAP条件下共培养是增强锥形微通道内血管生成的最佳条件。
研究设计与样本
- 在GelMA水凝胶(5%、7.5%、10% w/v,含或不含SCAP封装)中制作不同锥度(平行、0.04、0.06)的流体微通道。
- 将HUVECs-GFP单独或与SCAP共培养接种于微通道,用荧光和共聚焦显微镜及ImageJ评估血管生成出芽,免疫染色显示单层形成,数据采用单因素/双因素方差分析。
主要发现
- 仅接种HUVEC在微通道内形成内皮单层但无血管生成出芽。
- HUVECs-GFP/SCAPs以1:1比例共培养产生的出芽长度长于其他3种比例。
- 0.04锥度微通道内出芽平均长度显著长于平行和0.06锥度微通道。
- 5% GelMA水凝胶中观察到HUVEC-GFP出芽的显著差异。
- 水凝胶内封装SCAP进一步刺激HUVEC出芽。
临床怎么用
- 在牙髓再生中可考虑采用0.04锥度微通道、5% GelMA水凝胶并封装SCAP,联合1:1比例的SCAP与内皮细胞共培养以促进血管化。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
INTRODUCTION: The transplantation of stem cells/tissue constructs into root canal space is a promising strategy for regenerating lost pulp tissue. However, the root canal system, which is cone shaped with a taper from the larger coronal end to the smaller apical end, limits the vascular supply and, therefore, the regenerative capacity. The current study aimed to fabricate built-in microchannels with different tapers to explore various approaches to endothelialize these microchannels. METHODS: The fluidic microchannels with varying tapers (parallel, 0.04, and 0.06) were fabricated within gelatin methacryloyl (GelMA) hydrogel (with or without stem cell from the apical papilla [SCAP] encapsulation) of different concentrations (5%, 7.5%, and 10% [w/v]). Green fluorescent protein-expressing human umbilical vein endothelial cells (HUVECs-GFP) were seeded alone or with SCAPs in coculture into these microchannels. Angiogenic sprouting was assessed by fluorescence and a confocal microscope and ImageJ software (National Institutes of Health, Bethesda, MD). Immunostaining was conducted to illustrate monolayer formation. Data were statistically analyzed by 1-way/2-way analysis of variance. RESULTS: HUVEC-only inoculation formed an endothelial monolayer inside the microchannel without angiogenic sprouting. HUVECs-GFP/SCAPs cocultured at a 1:1 ratio produced the longest sprouting compared with the other 3 ratios. The average length of the sprouting in the 0.04 taper microchannel was significantly longer compared with that in the parallel and 0.06 taper microchannels. Significant differences in HUVEC-GFP sprouting were observed in 5% GelMA hydrogel. Encapsulation of SCAPs within hydrogel further stimulated the sprouting of HUVECs. CONCLUSIONS: The coculture of SCAPs and HUVECs-GFP at a ratio of 1:1 in 0.04 taper fluidic microchannels fabricated with 5% (w/v) GelMA hydrogel with SCAPs encapsulated was found to be the optimal condition to enhance angiogenesis inside tapered microchannels.
引用
- Qi Y, Zou T, Dissanayaka WL, et al. Fabrication of Tapered Fluidic Microchannels Conducive to Angiogenic Sprouting within Gelatin Methacryloyl Hydrogels. J Endod. 2020. PMID: 33045266. doi:10.1016/j.joen.2020.08.026
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。