动态导航技术辅助骨内麻醉的安全性与三维精度研究
本研究在3D打印颌骨模型上比较动态导航与徒手骨内注射麻醉的安全性和三维精度。结果显示动态导航组根穿孔率为0%,显著低于徒手组的22%(P < .05),且动态导航成功钻取100%注射位点,根间距离与精度偏差无关。
要点
- 动态导航骨内麻醉根穿孔率为0%,显著低于徒手注射的22%(P < .05)。
- 动态导航2D入口偏差0.71 mm,3D尖端偏差平均1.23 mm,角度偏差平均1.36°。
- 根间距离(1.5–4.5 mm)与动态导航的2D或3D偏差无显著关联。
核心结论
- 动态导航骨内麻醉在所有注射位点均成功且精确钻取,不受根间距离影响。
- 与徒手骨内钻取相比,动态导航显著更安全,可避免损伤邻近牙根。
研究设计与样本
- 使用6套相同的3D打印颌骨手术模型(TrueJaw),含54个根间位点。
- 注射位点按根间距离范围(1.5–2.5 mm、2.5–3.5 mm、3.5–4.5 mm)均匀分布。
- 由一名委员会认证的牙髓病医生随机采用徒手技术和Navident动态导航系统(配合X-Tip系统)完成骨内钻取。
- 使用Fisher精确检验比较根穿孔率,方差分析模型评估根间距离与精度指标的关系,显著性水平设为0.05。
主要发现
- 徒手组根穿孔率为22%,动态导航组为0%(P < .05)。
- 动态导航2D入口偏差为0.71 mm(95%CI,0.56–0.87)。
- 动态导航2D水平偏差平均0.96 mm(95%CI,0.79–1.14),2D垂直偏差平均0.70 mm(95%CI,0.55–0.84)。
- 动态导航3D尖端偏差平均1.23 mm(95%CI,1.05–1.42),3D角度偏差平均1.36°(95%CI,1.15–1.56)。
- 根间距离与任何2D或3D偏差均无显著关联。
临床怎么用
- 对于根间距离狭窄(1.5–4.5 mm)的骨内麻醉,动态导航可显著降低根穿孔风险。
- 动态导航下骨内钻取在根间距离1.5–4.5 mm范围内均能成功且精确完成。
局限性
- 研究基于3D打印颌骨模型,非真实患者,结论需临床进一步验证。
- 仅由一名操作者完成注射,未评估操作者间差异。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
INTRODUCTION: This study presents a novel method to deliver intraosseous anesthesia using dynamic navigation technology. The study aimed to evaluate its safety and 3-dimensional (3D) accuracy in comparison to traditional freehand injection of intraosseous anesthesia. METHODS: Six identical sets of 3D-printed surgical jaw models (TrueJaw; DELendo, Santa Barbara, CA) comprising simulated alveolar and dental anatomy with 54 interradicular sites were used in this study. The injection sites were equally distributed based on the range of the inter-radicular distance (ie, 1.5-2.5 mm, 2.5-3.5 mm, and 3.5-4.5 mm). A board-certified endodontist randomly completed intraosseous drilling at inter-radicular sites of varying distance using freehand technique and the Navident dynamic navigation system (ClaroNav, Toronto, Ontario, Canada) with the X-Tip system (Dentsply Sirona, York, PA). The rate of root perforation associated with inter-radicular distance was compared between the 2 groups using the Fisher exact test. Two-dimensional (2D) and 3D horizontal, vertical, and angulation discrepancies between the planned and dynamically navigated guide sleeves were digitally measured using superimposed cone-beam computed tomographic scans. Analysis of variance models were used to determine if the interdental distance was associated with the accuracy measures from the dynamic navigation system. The significance level was set at 0.05. RESULTS: The rate of root perforation was significantly higher for the freehand group than the dynamic navigation (22% vs 0%, P < .05). For dynamic navigation, the 2D entry deviation was 0.71 mm (95% confidence interval [CI], 0.56-0.87). The mean 2D horizontal deviation was 0.96 mm (95% CI, 0.79-1.14), and the mean 2D vertical deviation was 0.70 mm (95% CI, 0.55-0.84). The 3D deviation at the tip was on an average 1.23 mm (95% CI, 1.05-1.42). The overall 3D angular deviation was on average 1.36° (95% CI, 1.15-1.56). The inter-radicular distance was not significantly associated with any 2D or 3D discrepancies. CONCLUSIONS: Successful and accurate drilling of dynamically navigated intraosseous delivery occurred in 100% of injection sites irrespective of the inter-radicular distance. It was significantly safer in comparison to freehand intraosseous drilling to prevent injury of the roots of the adjacent teeth in close proximity.
引用
- Jain SD, Carrico CK, Bermanis I, et al. Intraosseous Anesthesia Using Dynamic Navigation Technology. J Endod. 2020. PMID: 32919987. doi:10.1016/j.joen.2020.09.001
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。