严重弯曲根管再治疗中不同器械系统及根尖扩大对充填物残留的影响
研究比较了四种旋转/往复镍钛系统在离体牙严重弯曲根管再治疗中的表现,并用显微CT测量充填物体积变化。结果显示各系统在基础再治疗后残留充填物无显著差异,但额外根尖扩大显著提高了清除效果。
要点
- 四种镍钛再治疗系统清除弯曲根管充填物的效果相当。
- 基础再治疗后使用大一号器械进行根尖扩大可显著减少充填物残留。
- 最终冲洗方案(EDTA后次氯酸钠)后的残留量需结合临床评估。
核心结论
- 四种测试器械系统在清除离体牙弯曲根管充填材料方面效果相同。
- 基础再治疗后使用更大号器械进行额外根尖扩大可改善充填物残留的清除。
研究设计与样本
- 离体牙实验研究,共使用65个圆形弯曲根管,随机分为四组。
- 根管用ProTaper Next预备至25号/.06锥度,并以环氧树脂封闭剂和牙胶充填。
- 再治疗分别使用ProTaper Universal Retreatment+ProTaper Gold、Reciproc Blue、Reciproc、Wave One Gold系统。
- 基础再治疗后各组用大一号器械行根尖扩大,并用显微CT在四个时间点测量充填物体积。
主要发现
- 各系统间残留充填物量及再治疗各阶段减少率均无显著差异(P > 0.05)。
- 组内分析显示,使用更大号最终器械在所有组中均显著去除更多充填材料(P < 0.001)。
关键数值与推荐
- 基础再治疗分别预备至PTG F2、RB25、R25、WOG25。
- 额外根尖扩大:I、II、III组至根尖40号,IV组至35号。
- 最终冲洗:15% EDTA后次氯酸钠冲洗。
- 充填物体积用工业显微CT测量四次:充填后、基础再治疗后、额外扩大后、最终冲洗后。
临床怎么用
- 对于弯曲根管再治疗,可选择任一测试镍钛系统进行基础清理。
- 基础再治疗后考虑使用大一号器械进行根尖扩大以增强充填物清除。
- 最终冲洗方案可包含EDTA和次氯酸钠以辅助清洁。
局限性
- 研究为离体牙实验,结果需临床验证。
- 样本为圆形弯曲根管,可能不适用于复杂解剖形态。
- 未评估不同冲洗液体积或激活方式的影响。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
AIM: To compare the retreatment ability of several rotary and reciprocating file systems in curved root canals of extracted teeth and to evaluate the influence of additional apical enlargement performed after a basic retreatment on the amount of remaining filling material. METHODOLOGY: A total of 65 round curved root canals were used. The root canals were prepared with the ProTaper Next rotary system to size 25, .06 taper and filled with an epoxy resin-based sealer and gutta-percha using continuous wave vertical compaction and warm injection back-filling. The canals were randomly divided into four groups according to the retreatment system used: Group I. ProTaper Universal Retreatment system + ProTaper Gold (PTG) instrumentation system up to PTG F2; Group II. Reciproc Blue system up to the instrument RB25; Group III. Reciproc system up to the instrument R25; Group IV. Wave One Gold (WOG) system up to the instrument WOG25. After the basic retreatment, additional apical enlargement was performed in each group with an instrument that was one size larger: in Group I, II and III up to apical size 40, and in Group IV up to 35. The final irrigation protocol included the following: 15% ethylenediaminotetraacetic acid followed by NaOCl irrigation. The volume of filling material was measured using an industrial micro-CT four times: after root canal filling (Volume I), after basic retreatment with size 25 files (Volume II), after additional root canal enlargement with larger instruments (Volume III), and after the final irrigation protocol (Volume IV). The decrease in the amount of filling material after each retreatment protocol was analysed using a Kruskal-Wallis test. Intergroup analyses were performed with a Kruskal-Wallis test and between-group differences were further analysed with Mann-Whitney U test. RESULTS: There were no significant differences amongst the systems tested in the amount of remaining filling material, or the reduction rates after each phase of the retreatment procedures (P > 0.05). Intragroup analysis indicated that the use of a larger final instrument removed significantly more filling material in all groups (P < 0.001). CONCLUSION: The four tested instrumentation systems were equally effective in removing filling materials from curved root canals in extracted teeth. Additional apical enlargement with larger files improved the removal of filling remnants after basic retreatment.
引用
- Bago I, Plotino G, Katić M, et al. Evaluation of filling material remnants after basic preparation, apical enlargement and final irrigation in retreatment of severely curved root canals in extracted teeth. Int Endod J. 2020. PMID: 32159859. doi:10.1111/iej.13287
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。