下颌磨牙近中根外科根尖倒预备设计的有限元应力分析第二部分
本研究采用有限元分析,探讨下颌磨牙近中根在根尖外科中倒预备设计与根尖填充材料对牙根应力集中的影响。结果显示,有倒充填时随预备腔扩大von Mises应力逐渐降低,无倒充填时则升高;向近中扩展预备可显著降低应力集中。结论提示近中向倒预备有利于形成低应力场,术中应避免冲脱倒充填材料。
要点
- 有倒充填时随预备腔扩大应力降低,无倒充填时应力升高
- 向近中扩展预备可显著降低近中根应力集中
- 术中应防止倒充填材料被冲出或脱落
核心结论
- 在下颌磨牙近中根近中牙本质内行倒预备,可保持根尖预备两侧牙本质平衡并形成低应力场。
- 术者应避免在充填过程中冲脱或移位倒充填材料,以防手术失败。
研究设计与样本
- 采用有限元分析,对下颌磨牙近中根进行应力分析。
- 填充材料分有或无三氧化矿物凝聚体(MTA)倒充填两种条件。
- 通过向近中扩展预备来修改根尖预备设计,并保持预备面积相近。
- 约束支持骨底部所有节点,沿垂直轴施加150 N的力。
主要发现
- 有倒充填时,随预备腔扩大,各亚组von Mises应力逐渐降低。
- 无倒充填时,随预备腔扩大,von Mises应力升高。
- 向近中方向扩展的根尖预备修改使应力集中显著下降。
临床怎么用
- 在近中根近中牙本质内行倒预备,以维持根尖预备两侧牙本质平衡并降低应力集中。
- 充填过程中注意避免冲脱或移位倒充填材料。
局限性
- 结论受本研究局限性约束。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
INTRODUCTION: The aim of this study was to investigate the influence of apical filling material and the modification made to the apical preparation design in surgical endodontics on the areas of stress concentration in the mesial root of a mandibular molar using finite element analysis. METHODS: The filling material was injected under 2 conditions (ie, with or without mineral trioxide aggregate retrograde filling). The apical preparation design was modified by extending the preparation mesially while maintaining a similar prepared area. We contained the displacement of all the nodes at the base of the supporting bone and applied a force of 150 N to the vertical axis. We analyzed stress generation and concentrations numerically for all cavity design groups. RESULTS: In the presence of retrograde filling, the von Mises stress decreased gradually according to the enlargement of the prepared cavity in the subgroups. When the retrograde filling was absent, the von Mises stress increased as the prepared cavity enlarged. The modification of the apical preparation extending in the mesial direction showed a drastic decrease in stress concentration. CONCLUSIONS: Within the limitations of this study, it was advantageous to perform mesial retrograde preparation within the mesial root dentin to maintain a balanced root dentin on both sides of the apical preparation and create a low-stress field. The surgeon should be careful not to wash out or dislodge the retrograde filling material during obturation to avoid failure of surgery.
引用
- Kim S, Chen D, Park SY, et al. Stress Analyses of Retrograde Cavity Preparation Designs for Surgical Endodontics in the Mesial Root of the Mandibular Molar: A Finite Element Analysis-Part II. J Endod. 2020. PMID: 32067720. doi:10.1016/j.joen.2019.12.007
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。