晚期牙周病磨牙拔除后牙槽突尺寸变化的临床初步研究
结果显示上颌和下颌中央嵴顶宽度在-1mm水平分别减少0.59/0.72mm(颊侧)和0.27/0.02mm(舌侧),上颌远腭区牙嵴高度降低1.11mm(p<0.05),下颌颊舌侧骨板高度显著降低0.56-1.38mm(p<0.05),但整体牙嵴高度变化上下颌间无显著差异(p>0.05),且6个月后上下颌拔牙窝均无显著体积性骨丧失。
要点
- 晚期牙周病磨牙拔除6个月后,中央嵴顶宽度在-1mm水平出现减小。
- 上颌远腭区牙嵴高度降低1.11mm(p<0.05),下颌颊舌侧骨板高度降低0.56-1.38mm(p<0.05)。
- 上下颌整体牙嵴高度变化无显著差异(p>0.05),且无显著体积性骨丧失。
核心结论
- 晚期牙周病磨牙拔除6个月后,拔牙窝中央中部区域尺寸显著增加,但水平宽度无显著变化。
主要发现
- 上颌和下颌中央嵴顶在-1mm水平宽度分别减少:颊侧0.59mm和0.72mm,舌侧0.27mm和0.02mm。
- 除上颌远腭区牙嵴高度降低1.11mm(p<0.05)外,其余区域牙嵴高度无统计学显著降低。
- 下颌颊侧和舌侧骨板高度在6个月愈合后显著降低,范围为0.56至1.38mm(p<0.05)。
- 上颌与下颌整体牙嵴高度变化无显著差异(p>0.05),且上下颌拔牙窝6个月后均无显著体积性骨丧失。
临床怎么用
- 对于晚期牙周病磨牙拔除后,应关注中央嵴顶宽度和下颌颊舌侧骨板高度的变化,为后续种植或修复计划提供参考。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
OBJECTIVE: To use cone beam computed tomography (CBCT) to assess the alterations of socket dimensions after a 6-month healing period following molar extraction. MATERIALS AND METHODS: Seventeen molars were extracted due to advanced periodontitis. CBCT scans were taken immediately after extraction and once more 6 months later. Superimposition of CBCT images was used to measure the following: horizontal changes at extraction sites at three corono-apical levels (-1, -3, and -5 mm) below the bone crest, three mesio-distal levels (mesial, central, and distal), vertical changes at nine regions of the alveolar crest, and alveolar bone volume. RESULTS: The width of the central crests at -1 mm decreased by 0.59 and 0.72 mm in the buccal and 0.27 and 0.02 mm in the lingual, in the maxilla and mandible, respectively. No statistically significant decreases in the ridge height were observed except in the disto-palatal region with a 1.11 mm decrease in the maxilla (p < 0.05). Heights of the buccal and lingual bone plates decreased significantly and ranged from 0.56 to 1.38 mm in the mandible after 6 months of healing (p < 0.05). Overall, ridge height changes were not significantly different between the maxilla and mandible (p > 0.05) and no significant volumetric bone loss occurred in either maxillary or mandibular sockets after 6 months of healing. CONCLUSIONS: Socket dimensions of molars with advanced periodontal disease showed a significant increase at the middle-central portion, although there were no significant changes of horizontal width 6 months following the procedures.
引用
- Zhao L, Wei Y, Xu T, et al. Changes in alveolar process dimensions following extraction of molars with advanced periodontal disease: A clinical pilot study. Clin Oral Implants Res. 2019. PMID: 30803050. doi:10.1111/clr.13418
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。