文献速递牙体牙髓病

不同影像学方法对根管解剖评估及牙髓科住院医师压力水平的影响

The Impact of Different Diagnostic Imaging Modalities on the Evaluation of Root Canal Anatomy and Endodontic Residents' Stress Levels: A Clinical Study.
PubMed 文献 · J Endod · 2019-02-13

结果显示CBCT及3D Endo软件在评估根管数目、解剖及工作长度方面显著优于仅根尖片,并能降低住院医师的操作压力。

要点

  • CBCT及3D Endo软件在根管数目、解剖及工作长度评估上显著优于单纯根尖片。
  • 3D Endo软件对工作长度的确定更准确,且能减少充填不足和空隙。
  • 使用CBCT或3D Endo软件可显著降低牙髓科住院医师的操作压力。

核心结论

  • 3D Endo软件及CBCT成像在评估根管解剖和工作长度方面更理想,并能降低住院医师的压力水平。

研究设计与样本

  • 三组分别使用根尖片、根尖片联合CBCT、以及联合CBCT与3D Endo软件进行影像学评估。

主要发现

  • 在评估根管数目、解剖及工作长度方面,CBCT组和CBCT联合3D Endo组均显著优于仅根尖片组(P < .001)。
  • 3D Endo软件组在工作长度确定上显著更准确(P = .002)。
  • 仅根尖片组中充填短于根尖(<2 mm)及存在空隙的病例数显著多于3D Endo软件组(P < .05,P < .01)。
  • 住院医师认为治疗中度或非常紧张的比例在仅根尖片组、CBCT组和3D Endo组分别为75%、5%和0%。

临床怎么用

  • 对于磨牙根管治疗,建议使用CBCT或3D Endo软件辅助评估根管解剖和工作长度,以提高准确性并降低操作压力。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

INTRODUCTION: The purpose of this study was firstly to compare the impact of radiographs, cone-beam computed tomographic (CBCT) imaging, and 3D Endo software (Dentsply Sirona, Ballaigues, Switzerland) on the assessment of root canal anatomy and radiographic quality of endodontic treatment and secondly to assess stress levels in the same cohort of residents performing endodontic treatment. METHODS: Sixty patients requiring primary molar endodontic treatment were allocated randomly into 3 groups: group 1 (n = 20), conventional radiographs (periapical radiography [PR]) only; group 2 (n = 20), PR and CBCT imaging; and group 3 (n = 20), PR, CBCT imaging, and 3D Endo software. All treatment was performed using a standardized protocol. Residents completed a questionnaire to assess their stress levels and usefulness of the imaging modality used. The radiographic quality of completed cases was assessed by 2 experienced endodontists who were not involved in the supervision of the cases being assessed. RESULTS: Groups 2 (CBCT imaging) and 3 (PR, CBCT imaging, and 3D Endo) proved significantly better than group 1 (PR) (P < .001) for assessing the number of root canals and anatomy and estimating the working lengths. Group 3 provided a significantly more accurate determination of the working level (P = .002). There were significantly more cases with obturation short of the apex (<2 mm) and voids in group 1 compared with group 3 (P < .05) and a significantly higher number of cases with voids in group 1 compared with group 3 (P < .01). Clinicians found treatment to be moderately or very stressful in 75%, 5%, and 0% in groups 1, 2, and 3, respectively. CONCLUSIONS: 3D Endo software followed by CBCT imaging were found to be more desirable for the evaluation of root canal anatomy and working lengths and reducing the residents' stress levels.

来源:J Endod,查看原文。版权归原作者所有。

引用

  1. Patel S, Patel R, Foschi F, et al. The Impact of Different Diagnostic Imaging Modalities on the Evaluation of Root Canal Anatomy and Endodontic Residents' Stress Levels: A Clinical Study. J Endod. 2019. PMID: 30770279. doi:10.1016/j.joen.2018.12.001

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。