文献速递口腔修复与种植儿童口腔

乳牙早失加剧牙槽骨吸收影响种植

Alveolar bone resorption after primary tooth loss has a negative impact on straightforward implant installation in patients with agenesis of the lower second premolar.
PubMed 文献 · Clin Oral Implants Res · 2017-07-23

研究比较150份下颌CT中第二前磨牙先天缺失伴或不伴乳牙存留的牙槽骨尺寸,发现乳牙缺失≥3个月后冠部颊舌向宽度显著减小,常规种植可行性降低且更多需植骨。建议尽量保留乳第二磨牙。

要点

  • 乳牙缺失≥3个月后牙槽嵴冠部颊舌向宽度显著减小。
  • 乳牙存留时常规种植模拟可行率86%,缺失后降至62%。
  • 乳牙缺失组28%患者实际需额外硬组织增量。

核心结论

  • 乳牙缺失≥3个月的下颌第二前磨牙先天缺失位点牙槽嵴冠部尺寸显著小于乳牙存留位点。
  • 建议尽量保留乳第二磨牙以利于常规种植并减少植骨概率。

研究设计与样本

  • 回顾性评估150份下颌CT,分三组:乳牙存留组(AW)、乳牙缺失≥3个月组(AWO)、正常对照组(CTR)。
  • 数字化模拟3.5或4.3 mm直径×10 mm长种植体常规植入可行性并与实际治疗比较。

主要发现

  • AWO组牙槽嵴冠部颊舌向宽度7.3±2.0 mm,显著小于AW组9.2±1.4 mm和CTR组9.5±1.1 mm。
  • 宽度减少主要因牙槽嵴颊侧塌陷。
  • 模拟常规植入3.5 mm和4.3 mm直径种植体:AWO组可行率62%和56%,AW组86%和84%(p=.006和.002)。
  • AW组全部22例患者实际常规种植可行,AWO组39例中11例(28%)需额外硬组织增量。

关键数值与推荐

  • AWO组冠部颊舌向宽度7.3±2.0 mm,AW组9.2±1.4 mm,CTR组9.5±1.1 mm。
  • 模拟常规植入可行率AWO组62%(3.5 mm)和56%(4.3 mm),AW组86%和84%,组间p=.006和.002。
  • AWO组28%(11/39)需额外硬组织增量,AW组0%(0/22)。

临床怎么用

  • 对下颌第二前磨牙先天缺失患者,尽量保留乳第二磨牙以维持牙槽嵴宽度。
  • 乳牙已缺失≥3个月者,种植前评估需考虑硬组织增量可能。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

OBJECTIVES: To compare the alveolar bone dimensions in patients with lower second premolar (P2) agenesis prior to and after primary molar loss on CT scans, and assess the possibility for straightforward implant placement. METHODS: Alveolar bone dimensions were evaluated on 150 mandibular CT scans in three groups: (i) agenesis of P2, with the primary tooth in situ, and regularly erupted first premolar (P1) and molar (M1) (AW); (ii) agenesis of P2, without the primary tooth in situ for ≥3 m, but regularly erupted P1 and M1 (AWO); and (iii) P1, P2, and M1 regularly erupted (CTR). The possibility of straightforward placement of an implant 3.5 or 4.3 mm in Ø × 10 mm long was digitally simulated and compared to the actually performed treatment. RESULTS: Buccolingual width (7.3 ± 2.0 mm) at the coronal aspect of the ridge in the AWO group was statistically significantly smaller comparing with both the AW (9.2 ± 1.4 mm) and the CTR (9.5 ± 1.1 mm) group; width reduction appeared to be mainly due to "collapse" of the buccal aspect of the ridge. Simulated straightforward placement of implants with a diameter of 3.5 or 4.3 mm was possible in 62% and 56% of the cases in the AWO vs. 86% and 84% in the AW group (p = .006 and .002, respectively). Straightforward implant placement was actually possible in all patients (22) in the AW group, while 28% (11 of 39) of the patients in the AWO group needed additional hard tissue augmentation. CONCLUSIONS: Significant dimensional differences exist in the alveolar ridge, especially in the coronal part, at lower P2 agenesis sites missing the primary tooth for ≥3 m, when compared to P2 agenesis sites with the primary tooth in situ. It seems thus reasonable to advise that the primary second molar should be kept as long as possible, in order to facilitate straightforward implant installation and reduce the probability of additional bone augmentation procedures.

来源:Clin Oral Implants Res,查看原文。版权归原作者所有。

引用

  1. Bertl K, Bertl MH, Heimel P, et al. Alveolar bone resorption after primary tooth loss has a negative impact on straightforward implant installation in patients with agenesis of the lower second premolar. Clin Oral Implants Res. 2017. PMID: 28736870. doi:10.1111/clr.13033

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。