初始牙槽嵴缺损形态对萎缩性下颌后部骨增量后种植体结局的影响:一项探索性回顾性研究
本回顾性研究纳入52例患者共71个无牙区、185枚种植体,平均随访37.97个月,按ABC分类评估初始萎缩性下颌后部缺损形态对骨增量后种植体结局的影响。总体生存率98.91%、成功率80%;初始CII类缺损种植体边缘骨吸收最高(1.26 mm ± 0.99),AII类最低(0.48 mm ± 0.78),C类与A类(I、II)及BII类间边缘骨吸收差异有统计学意义(P < 0.05)。作者认为A类和B类缺损可能比C类更有利,需随机对照试验进一步验证。
要点
- 总体种植体生存率98.91%,成功率80%,平均随访37.97个月。
- 初始CII类缺损边缘骨吸收最高(1.26 mm ± 0.99),AII类最低(0.48 mm ± 0.78)。
- C类与A类(I、II)及BII类间边缘骨吸收差异有统计学意义(P < 0.05)。
核心结论
- 初始牙槽嵴形态影响骨增量后种植体结局,A类和B类缺损可能比C类更有利。
- 该结论基于A类和B类骨增量位点种植体边缘骨吸收较少、C类位点边缘骨吸收较高。
- 作者认为需要随机对照试验来检验这些探索性观察结果。
研究设计与样本
- 探索性回顾性研究,52例患者共71个无牙区,植入185枚种植体,平均随访37.97个月。
- 初始缺损形态按ABC分类(Journal of Oral Implantology, 37, 2013a and 361)分类。
- 采用皮质骨自体帐篷技术(CAT)行嵴增量,同期或经过4-6个月愈合后延期植入种植体。
- 采用欧洲骨结合学会成功标准评价种植体结局。
主要发现
- 种植体总体生存率为98.91%,成功率为80%。
- CAT组随访2年时累积成功率为95%、累积生存率为100%。
- 初始窄而平牙槽嵴(缺损CII类)的骨增量无牙区位点种植体边缘骨吸收最高(1.26 mm ± 0.99)。
- 初始有两个倾斜骨壁(缺损AII类)的无牙区位点种植体边缘骨吸收最低(0.48 mm ± 0.78)。
- 初始缺损C类与A类(I、II)及BII类之间种植体边缘骨吸收差异有统计学意义(P < 0.05)。
关键数值与推荐
- 种植体结局采用欧洲骨结合学会成功标准评价。
- 初始缺损形态采用ABC分类(Journal of Oral Implantology, 37, 2013a and 361)分类。
临床怎么用
- 作者认为A类和B类萎缩性牙槽嵴缺损(分别有一个和两个垂直骨壁)可能比平坦形态的C类缺损更有利作为受植区。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
OBJECTIVES: Clinicians commonly consider atrophic site topography as an important determinant in deciding the augmentation technique to utilize, as well as forecasting the likelihood of success. The purpose of this retrospective study was to examine the influence of initial atrophic posterior mandible morphology on the outcome of implants placed following augmentation. MATERIALS AND METHODS: A total of 52 patients contributed 71 edentulous sites, and 185 implants were placed with mean follow-up of 37.97 months. The initial defect morphology was classified according to ABC classification (Journal of Oral Implantology, 37, 2013a and 361). Ridge augmentation was performed by "cortical autogenous tenting" (CAT) followed by either simultaneous or delayed implant placement after 4-6 months of healing. The European Academy of Osseointegration success criteria were used to evaluate implant outcomes. RESULTS: The overall survival and success rates of dental implants were 98.91% and 80%, respectively. Cumulative success and survival rates in CAT group were 95% and 100% after 2 years of follow-up. The highest marginal bone loss (MBL) was observed (1.26 mm ± 0.99) around implants placed in augmented edentulous sites with initially narrow and flat alveolar crest (defect class CII). Conversely, least MBL (0.48 mm ± 0.78) was detected around implants placed into edentulous sites with two sloped boney walls (defect class AII). Differences between MBL observed around implants placed into initial defect class C, initial defect type and class A (I, II), as well as class BII, were statistically significant (P < 0.05). Among all implants, 148 were considered as successful, 26 exhibited satisfactory survival, nine with compromised survival, and two implants failed. CONCLUSION: The present data confirmed the effect of initial ridge morphology on the outcome of implants placed into augmented bone. Specifically, class A and class B atrophic ridge defects, with one and two vertical boney walls, respectively, may be considered as more favorable recipient sites than class C defects with flat morphology. This conclusion is based on least MBL around implants placed into initial defect class A and class B augmented sites, and higher MBL in implants placed into class C recipient sites. A randomized controlled trial is warranted to examine these exploratory observations.
引用
- Khojasteh A, Motamedian SR, Sharifzadeh N, et al. The influence of initial alveolar ridge defect morphology on the outcome of implants in augmented atrophic posterior mandible: an exploratory retrospective study. Clin Oral Implants Res. 2016. PMID: 27804178. doi:10.1111/clr.12991
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。