根尖预备规划方案:最大化根管壁器械覆盖并保持牙本质结构完整性
混合方案将未预备根管壁频率从ProTaper Ultimate的53.8%降至13.0%,且唯一无剩余牙本质厚度小于0.5 mm的截面。
要点
- 混合器械规划使未预备根管壁频率降至13.0%,较ProTaper Ultimate降低76%。
- 混合方案是唯一在400个截面中均无剩余牙本质厚度小于0.5 mm的策略。
- 单系统方案未预备壁频率最低为ProTaper Ultimate的53.8%,其余更高。
核心结论
- 新型个性化混合器械规划方案在显著减少未预备根管壁的同时,避免了剩余牙本质厚度低于0.5 mm的临界变薄。
研究设计与样本
- 虚拟预备比较5种镍钛单系统(ProTaper Ultimate、Reciproc Blue、SRF Sequence MKLife、HyFlex EDM、WaveOne Gold)与一种允许跨系统器械及手用K锉的混合规划方案。
- 主要结局为未预备根管表面和剩余牙本质厚度小于0.5 mm,采用配对风险比、精确McNemar检验和贝叶斯因子分析。
主要发现
- 平均根管锥度为0.08 mm/mm,平均纵横比为1.40±0.59。
- 单系统中ProTaper Ultimate未预备表面频率最低,为215/400(53.8%)。
- 混合方案将未预备表面降至52/400(13.0%),较ProTaper Ultimate风险比为4.13(95%CI 3.20–5.34,P<.001),降低76%。
- 混合方案是唯一无截面出现剩余牙本质厚度小于0.5 mm的策略(0/400),单系统方案范围为1.8%至4.5%。
关键数值与推荐
- 剩余牙本质厚度安全阈值设定为至少0.5 mm。
- 混合方案允许根据截面情况选用多个系统的镍钛器械及必要时手用K锉。
- 混合方案在两个主要结局上均显著优于所有测试的单系统策略。
临床怎么用
- 临床进行根尖预备规划时可考虑跨系统组合器械及手用K锉,以兼顾根管壁覆盖与牙本质保存。
- 规划时应利用影像评估根管锥度、纵横比及剩余牙本质厚度,个体化选择器械。
局限性
- 研究仅针对上颌侧切牙的虚拟预备,未涵盖其他牙位或临床操作变量。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
INTRODUCTION: This study developed a personalized root canal instrumentation planning protocol designed to minimize uninstrumented canal walls while preserving a remaining dentin thickness (RDT) of at least 0.5 mm and compared it with the best available planning protocol. METHODS: One hundred maxillary lateral incisors were scanned by microcomputed tomography, and 400 cross-sections were analyzed at 1, 2, 3, and 4 mm from the apical foramen. Canal diameters, aspect ratio, and minimum RDT were measured. Virtual preparation was planned using 5 nickel titanium systems (ProTaper Ultimate, Reciproc Blue, SRF Sequence MKLife, HyFlex EDM, and WaveOne Gold) individually and a new hybrid protocol allowing instruments from multiple systems and hand K-files when necessary. The primary outcomes were uninstrumented canal surfaces and an RDT <0.5 mm. Paired risk ratios, exact McNemar tests, and Bayes factors were calculated. RESULTS: The mean canal taper was 0.08 mm/mm, and the mean aspect ratio was 1.40 ± 0.59. Among single-system protocols, ProTaper Ultimate produced the lowest frequency of uninstrumented surfaces (215/400; 53.8%). The new protocol reduced this frequency to 52 of 400 (13.0%), corresponding to a 76% reduction versus ProTaper Ultimate (risk ratio of 4.13; 95% confidence interval, 3.20-5.34; P < .001). The hybrid protocol was also the only strategy with no sections presenting RDT <0.5 mm (0/400), whereas single-system protocols ranged from 1.8% to 4.5%. The protocol significantly outperformed every tested single-system strategy for both primary outcomes. CONCLUSIONS: The new personalized hybrid instrumentation planning substantially reduced uninstrumented canal surfaces while preventing critical dentin thinning compared with existing customized single-system protocols.
引用
- Carvalho de Sousa B, Cunha D'Assunção FL, Caldeira CL, et al. Planning Protocol for Apical Preparation Maximizing Root Canal Wall Instrumentation and Preserving Root Dentin Structural Integrity. J Endod. 2026. PMID: 42833550. doi:10.1016/j.joen.2026.09.013
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。