下颌第一恒磨牙近中根管矢状面与冠状面弯曲度比较:基于CBCT的横断面研究
结果显示矢状面弯曲角度更大、半径更小,Weine法角度更高;矢状面重度单弯曲更常见,冠状面S形根管更常见,纳入半径使难度分级升高。
要点
- 矢状面比冠状面显示更严重的单弯曲,冠状面S形根管更常见。
- Weine法较Schneider法得出更大弯曲角度和更小半径。
- 将弯曲半径纳入难度评估系统会使病例严重度分级升高。
核心结论
- 矢状面显示更严重的单弯曲,冠状面S形根管更常见。
- Weine法较Schneider法得出更大的弯曲严重度。
- 纳入弯曲半径会增加病例严重度分级。
研究设计与样本
- 在矢状面和冠状面分别用Schneider法和Weine法测量弯曲角度并几何计算弯曲半径。
- 采用美国牙体牙髓病学会病例难度评估表、EndoApp及纳入弯曲和半径的修改版进行严重度分类。
- 使用t检验和卡方检验,显著性设为p ≤ 0.05。
主要发现
- 矢状面弯曲角度显著大于冠状面,弯曲半径显著小于冠状面。
- Weine法较Schneider法角度更高、半径更小。
- 重度单弯曲(≥ 30°)在矢状面更常见,S形根管在冠状面更常见。
- 近中颊根管较近中舌根管更常被归为更高难度。
- 将半径纳入分类系统通常使病例向更严重方向偏移。
关键数值与推荐
- 重度单弯曲定义为弯曲角度≥ 30°。
- 采用美国牙体牙髓病学会病例难度评估表、EndoApp及纳入弯曲和半径的修改版进行严重度分类。
临床怎么用
- 根管治疗计划和研究应同时考虑测量方法与投影平面。
- 评估近中根管弯曲时宜结合矢状面和冠状面信息。
- Weine法可能高估弯曲严重度,解读时需注意方法差异。
- 将弯曲半径纳入难度评估有助于更全面判断病例复杂性。
局限性
- 仅基于巴西人群样本,外推需谨慎。
- 为CBCT横断面研究,未报告临床结局。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
BACKGROUND: There is a strong association between root canal curvatures and iatrogenic complications during root canal treatment. INTRODUCTION: This study compared the curvature of mesiobuccal (MB) and mesiolingual (ML) canals in mandibular first molars between sagittal and coronal planes using cone-beam computed tomography. METHODS: Two hundred mesial roots (400) canals from a Brazilian subpopulation were analysed. Curvature angles were measured in sagittal and coronal planes using Schneider's and Weine's methods, while curvature radii were calculated geometrically. The prevalence of S-shaped canals was also recorded. Curvature severity was classified according to the American Association of Endodontists Case Difficulty Assessment form, EndoApp, and modified versions incorporating curvature and radius. The influence of the angle measurement method and radius on case complexity was evaluated. Statistical analyses were performed using t-tests and chi-squared tests, with significance set at p ≤ 0.05. RESULTS: Sagittal planes showed significantly greater angles and smaller radii than coronal planes. Weine's method yielded consistently higher angles and smaller radii than Schneider's. Severe single curvatures (≥ 30°) were more frequent in sagittal planes, whereas S-shaped canals were more prevalent in coronal planes. MB was more often classified as higher difficulty than ML canals. Incorporating radius into the classification systems generally shifted cases towards greater severity. CONCLUSIONS: Sagittal planes revealed more severe single curvatures, whereas coronal planes showed a higher prevalence of S-shaped canals. Weine's method resulted in greater curvature severity than Schneider's. Inclusion of radius increased case severity grading. These findings highlight the importance of considering both measurement method and projection plane in endodontic treatment planning and research.
引用
- Mathew AI, Decurcio DA, Estrela C, et al. Comparison of Curvature Severity Between Sagittal and Coronal Planes of Mesial Canals in Permanent Mandibular First Molars Using Schneider's and Weine's Methods and Multiple Complexity-Risk Criteria: A Cone-Beam Computed Tomography Cross-Sectional Study. Int Endod J. 2025. PMID: 41287941. doi:10.1111/iej.70072
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。