文献速递牙体牙髓病

超声诱导流对根管侧支内流场影响的体外研究

An In Vitro Investigation of the Impact of Ultrasound Induced-Streaming Motions on the Flow Inside Lateral Features of the Root Canal.
PubMed 文献 · Int Endod J · 2025-10-24

该体外研究用3D打印理想化根管模型结合粒子图像测速技术,表征超声冲洗时侧支内的流场。结果表明,锉针位置与侧支角度显著影响侧支内流速,锉尖与90°侧支轴对齐时流速最大,提示更有效清洁的优化位置。

要点

  • 锉针位置显著影响侧支内流速与流向。
  • 90°侧支轴与射流对齐时流速最大。
  • 60°侧支流速较低且以回流为主。

核心结论

  • 超声冲洗时侧支内流场复杂,受锉针位置和侧支角度显著影响。
  • 锉尖最佳位置可使侧支内诱导速度最大化,提示清洁更有效。

研究设计与样本

  • 体外实验研究,采用3D打印理想化根管模型。
  • 模型为20 mm锥度6%根管,根尖直径0.4 mm,侧支长5 mm、200 μm方形截面,距根尖6 mm,与根管轴成90°或60°。
  • 通道材料为PEG修饰亲水PDMS,填充NaI水溶液并播撒1 μm粒子。
  • 使用15# K锉的超声仪冲洗,粒子图像测速表征流场。

主要发现

  • 侧支内流动受锉针位置显著影响,射流冲击根管壁与锉针周围回流竞争,导致流入侧支或抽吸产生向根管回流。
  • 射流与侧支轴对齐可最大化侧支内速度,仅90°侧支可实现该对齐。
  • 60°侧支流速较低,回流至根管占主导。
  • 两种角度下侧支入口附近均形成回流区,横向速度与轴向速度相当,回流区长度受侧支倾斜影响。
  • 侧支更深处流动变为单轴。

临床怎么用

  • 超声冲洗时锉针位置影响侧支清洁效果,锉尖与侧支轴对齐可能提高侧支内流速。
  • 侧支角度影响冲洗流场,60°侧支更易出现回流而非流入。

局限性

  • 研究为体外理想化模型,使用NaI水溶液和1 μm粒子,非真实根管系统与冲洗液。
  • 仅测试90°和60°两种侧支角度及特定尺寸侧支。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

AIM: The study aims to experimentally characterize the flow inside lateral canals during ultrasonic irrigation. The effect of the canal angle as well as the relative position of the endodontic file with the inlet of the channel was quantified. METHODOLOGY: An idealized endodontic geometry was 3D printed and used as a mould to fabricate a channel made of PEG-modified hydrophilic PDMS. The mould comprises a 20 mm tapered (6%) root canal with a 0.4 mm apical diameter and a 5 mm long lateral canal with a 200 μm square cross section, forming an angle of either 90° or 60° with the axis of the root canal and placed 6 mm from the apex. The channel was filled with a NaI-water solution and seeded with 1 μm particles. An ultrasonic instrument with a 15# K-file was employed for the irrigation. The flow field was characterized by Particle Image Velocimetry. RESULTS: The flow inside the lateral canals is notably affected by the position of the endodontic file. There is a competition between the impingement of the ultrasound-induced jets on the walls of the root canal and the recirculation flows around the file, leading to either flow into the lateral canal or suction phenomena that generate backflow towards the root canal. Aligning the jet with the axis of the lateral canal maximizes the magnitude of the velocities that can be achieved therein. This alignment can only be achieved in the 90° channel. Inclining the lateral canal to 60° leads to lower velocities and a domination of the backflows towards the root canal. In both cases, a recirculation zone forms near the inlet of the channel where transverse velocities are comparable with the axial ones. The recirculation zone length is affected by the inclination of the channel. Further inside the canal, the flow becomes uniaxial. CONCLUSION: The flow during ultrasonic irrigation inside lateral features of the root canal is complex and considerably affected by the position of the endodontic file and the inclination of the channel. An optimum location of the file tip leads to maximization of the induced velocity inside the lateral canal, suggesting more effective cleaning.

来源:Int Endod J,查看原文。版权归原作者所有。

引用

  1. Koulogiannis A, Walmsley AD, Angeli P, et al. An In Vitro Investigation of the Impact of Ultrasound Induced-Streaming Motions on the Flow Inside Lateral Features of the Root Canal. Int Endod J. 2025. PMID: 41132083. doi:10.1111/iej.70057

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。