文献速递口腔正畸

安氏II类拔牙隐形矫治切牙移动与牙槽骨变化的CBCT分析

CBCT analysis of incisor movement and alveolar bone changes in class two malocclusion treatment with premolar extraction using clear aligner: a retrospective study.
PubMed 文献 · J Dent · 2025-09-04

本回顾性研究通过CBCT分析38颗上颌和37颗下颌切牙,评估成人安氏II类拔牙隐形矫治中牙槽骨改建与切牙位移的关联。结果显示上颌切牙唇侧骨增厚而腭侧骨吸收,上下颌骨反应不同,提示需优化转矩设计并CBCT监控。

要点

  • 上颌切牙唇侧骨增厚,腭侧骨吸收,需关注腭侧骨改建。
  • 上下颌切牙牙槽骨对隐形矫治力学反应存在差异。
  • 建议采用转矩优化的矫治器设计并配合CBCT监控。

核心结论

  • 上下颌牙槽骨对隐形矫治力学反应不同,需转矩优化设计和CBCT监控以减少过度吸收。

研究设计与样本

  • 回顾性研究,分析38颗上颌和37颗下颌切牙的CBCT扫描,量化四个解剖标志点的位移向量并测量牙槽骨厚度。

主要发现

  • 上颌切牙唇侧骨增厚(中切牙+0.36±0.44 mm,侧切牙+0.15±0.42 mm),腭侧骨吸收(中切牙-0.43±0.64 mm,侧切牙-0.22±0.92 mm,P<0.05)。
  • 上颌中切牙根尖处腭侧骨中根厚度(B2-B2')与位移呈负相关(P<0.05),侧切牙唇侧骨中根厚度(A2-A2')与C、M位移呈正相关(P<0.05)。
  • 下颌中切牙中根水平与C、M、R、L点呈负相关(P<0.01),M点与B2-B2'的多重回归显著(P<0.05)。

临床怎么用

  • 临床中应关注安氏II类拔牙隐形矫治患者上颌切牙腭侧骨吸收风险,考虑转矩优化设计。
  • 建议使用CBCT监控牙槽骨改建,尤其下颌中切牙中根水平。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

OBJECTIVES: This retrospective study evaluates alveolar bone remodeling patterns and their association with incisor displacement in adults undergoing clear aligner therapy with premolar extractions for Class II malocclusion correction. METHODS: Cone-beam computed tomography (CBCT) scans of 38 maxillary and 37 mandibular incisors were analyzed. Displacement vectors for four anatomical landmarks (cusp tip [C], root apex [R], root neck midpoint [M], labial cementoenamel junction [L]) were quantified. Alveolar bone thickness was measured at mid-root and apical levels. Statistical analyses included Spearman correlations and multivariate regression. RESULTS: Post-treatment maxillary incisors demonstrated labial bone thickening (+0.36±0.44 mm central; +0.15±0.42 mm lateral) with concurrent palatal bone resorption (-0.43±0.64 mm central; -0.22±0.92 mm lateral, P< 0.05). Negative correlations emerged between mid-root thickness of the palatal bone (B2-B2') at R in central incisors (P < 0.05), while lateral incisors showed positive associations between mid-root thickness of labial bone (A2- A2')and C and M displacements (P < 0.05). Mandibular central incisors showed a negative correlation at the mid-root level with points C, M, R, and L (P<0.01), and a multiple regression highlight between point M and (B2-B2') (P<0.05). CONCLUSIONS: Differential maxillary-mandibular bone responses to clear aligner mechanics highlight the necessity for torque-optimized aligner designs and CBCT-monitored treatment staging to mitigate excessive resorption.

来源:J Dent,查看原文。版权归原作者所有。

引用

  1. Li J, Liu R, Yao Y, et al. CBCT analysis of incisor movement and alveolar bone changes in class two malocclusion treatment with premolar extraction using clear aligner: a retrospective study. J Dent. 2025. PMID: 40914271. doi:10.1016/j.jdent.2025.106090

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。