开发一种评估生物膜与人类牙本质粘附强度的新型实验室方法
本研究采用流体动力测量(FDG)与计算流体动力学(CFD)定量多物种生物膜从人牙本质表面脱离所需的剪切力。多物种生物膜在人类磨牙牙本质切片上生长3、7、14天,FDG以不同吸流率(100%、80%、40%)评估生物膜去除,最大吸流率100%时为500 mL/min。结果显示任何实验组均无法完全去除生物膜,3天生物膜去除所需剪切力显著低于7天或14天生物膜,14天生物膜组在所有测试流率下剪切力最大。
要点
- FDG结合CFD首次定量多物种生物膜从牙本质脱离所需剪切力。
- 任何实验组均无法用纯水完全去除多物种生物膜。
- 3天生物膜去除所需剪切力显著低于7天或14天生物膜。
核心结论
- 本研究首次记录去除牙本质表面多微生物生物膜所需的力。
- 在本研究限度内,成熟生物膜去除需要更大的剪切力。
- 这对规划生物膜去除方案具有重要意义。
研究设计与样本
- 多物种生物膜在人类磨牙2 mm厚牙本质切片上生长3、7、14天,每组n=8。
- 采用FDG技术以不同吸流率(100%、80%、40%)评估生物膜去除,最大吸流率100%时为500 mL/min。
- 染色牙本质样本在施加各吸流率前后以10倍放大拍摄数字图像。
- 使用Image J©和Colormine©软件测定颜色饱和度变化值(△E)以评估生物膜去除。
- 通过CFD估算施加的剪切力并与△E值进行关联。
主要发现
- FDG和CFD分析显示,以水作为测量液体在任何实验组均无法完全去除生物膜。
- 3天生物膜去除所需剪切力显著低于7天或14天生物膜。
- 14天生物膜组在所有测试流率下剪切力最大。
- 评估牙本质残留生物膜时,100%流率下所有时间段的△E值显示残留生物膜约为40%。
- 任何实验组均无法完全去除多物种生物膜。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
INTRODUCTION: Biofilms may show varying adherence strengths to dentine. This study quantified the shear force required for the detachment of multispecies biofilm from the dentine using fluid dynamic gauging (FDG) and computation fluid dynamics (CFD). To date this force has not been quantified. METHODS: Multispecies biofilms were grown over 3, 7 and 14 days on 2 mm thick dentine sections of human molars (n = 8 per group). The FDG technique with different suction flow rates (100%, 80% and 40%) was used to assess biofilm removal. At maximum suction (100%), the flow rate was 500 mL/min. Digital images of each stained dentine sample were captured (10× magnification) before and after subjecting the samples to the various suction flow rates. The change in colour saturation versus control (△E) value was determined to assess removal of biofilm using digital softwares (Image J© and Colormine©). The imposed shear forces were then estimated using CFD and correlated with the △E values. RESULTS: FDG and CFD analysis showed that complete removal of biofilm by using water as the gauging liquid was not possible across any of the experimental groups. Three-day biofilms required significantly lower shear forces for removal than 7-day or 14-day biofilms. The maximum shear forces were seen in the 14-day biofilm group at all flow rates tested. When assessing for residual biofilm on the dentine, the △E value showed residual biofilms of approximately 40% at all time periods at a 100% flowrate. Complete removal of multispecies biofilm was not possible in any experimental group. CONCLUSIONS: This study for the first-time records forces needed to remove polymicrobial biofilms form the surface of a dentine sample. Within the limits of this study, mature biofilms require greater shear forces for removal. This is important when planning protocols for biofilm removal.
引用
- Bulmer J, Chew YMJ, George R, et al. Development of a novel laboratory approach for evaluating the adhesion strength of biofilms to human dentine. Int Endod J. 2025. PMID: 39812648. doi:10.1111/iej.14196
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。