阳极氧化与喷砂种植体表面在引导骨再生急性开裂型缺损中的骨结合:小型猪下颌模型
该对照临床前研究利用小型猪下颌3 mm×3 mm急性颊侧开裂型缺损模型,以脱蛋白牛骨矿物和猪胶原膜进行引导骨再生,比较梯度阳极氧化(NGA)种植体与两种大颗粒喷砂酸蚀(SLA)种植体(超亲水与相对疏水)的骨结合与冠向骨形成。结果显示新骨形成量与高度在各组间无差异,但两种SLA表面在2周和8周时骨结合与冠向骨爬行显著优于NGA表面。
要点
- SLA表面种植体在开裂缺损中的骨结合与冠向骨爬行显著优于梯度阳极氧化表面。
- 种植体表面类型不影响引导骨再生后的新骨形成量与高度。
- 小型猪急性开裂缺损模型可用于评估种植体表面特性对骨结合的影响。
核心结论
- 种植体表面类型不影响新骨形成量(BATA)与新骨高度(NBH),但大颗粒喷砂酸蚀表面在开裂缺损中的骨结合(dBIC)与冠向骨沉积(fBIC)显著优于梯度阳极氧化表面(p < 0.05)。
研究设计与样本
- 对照临床前研究,采用标准化3 mm×3 mm急性颊侧开裂型小型猪下颌模型,以脱蛋白牛骨矿物移植并覆盖猪胶原膜,于2周和8周愈合期进行组织学与组织形态计量分析,比较三组种植体:梯度阳极氧化(NGA)种植体、超亲水微粗糙大颗粒喷砂酸蚀种植体、相对疏水微粗糙大颗粒喷砂酸蚀种植体。
主要发现
- 2周和8周时,各组新骨形成量(BATA)与新骨高度(NBH)无差异(p > 0.05)。
- 2周和8周时,第2组和第3组的首次骨-种植体接触(fBIC)与垂直骨爬行(VBC)显著高于第1组(p < 0.05)。
- 8周时,第2组和第3组开裂区骨-种植体接触(dBIC)显著高于第1组(p < 0.05)。
临床怎么用
- 在引导骨再生处理急性开裂型缺损时,选择大颗粒喷砂酸蚀表面种植体可能获得更优的骨结合与冠向骨沉积。
- 梯度阳极氧化表面种植体在开裂缺损中的骨结合表现劣于SLA表面,临床选择时需权衡。
局限性
- 本研究为小型猪动物模型,结果需临床研究验证。
- 仅评估2周和8周两个时间点,缺乏长期数据。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
OBJECTIVES: This controlled preclinical study analyzed the effect of implant surface characteristics on osseointegration and crestal bone formation in a grafted dehiscence defect minipig model. MATERIAL AND METHODS: A standardized 3 mm × 3 mm acute-type buccal dehiscence minipig model grafted with deproteinized bovine bone mineral and covered with a porcine collagen membrane after 2 and 8 weeks of healing was utilized. Crestal bone formation was analyzed histologically and histomorphometrically to compare three implant groups: (1) a novel, commercially available, gradient anodized (NGA) implant, to two custom-made geometric replicas of implant "1," (2) a superhydrophilic micro-rough large-grit sandblasted and acid-etched surface, and (3) a relatively hydrophobic micro-rough large-grit sandblasted and acid-etched surface. RESULTS: At 2 and 8 weeks, there was no difference between the amount and height of newly formed bone (NBH, new bone height; BATA, bone area to total area) for any of the groups (p > 0.05). First bone-to-implant contact (fBIC) and vertical bone creep (VBC) at 2 and 8 weeks were significantly increased for Groups 2 and 3 compared to Group 1 (p < 0.05). At 8 weeks, osseointegration in the dehiscence (dehiscence bone-implant-contact; dBIC) was significantly higher for Groups 2 and 3 compared to Group 1 (p < 0.05). CONCLUSIONS: The amount of newly formed bone (BATA) and NBH was not influenced by surface type. However, moderately rough surfaces demonstrated significantly superior levels of osseointegration (dBIC) and coronal bone apposition (fBIC) in the dehiscence defect compared to the NGA surface at 2 and 8 weeks. TRIAL REGISTRATION: For this type of study, clinical trial registration is not required. This study was conducted at the Biomedical Department of Lund University (Lund, Sweden) and approved by the local Ethics Committee of the University (M-192-14).
引用
- Shahdad S, Rawlinson S, Razaghi N, et al. Osseointegration of Anodized vs. Sandblasted Implant Surfaces in a Guided Bone Regeneration Acute Dehiscence-Type Defect: An In Vivo Experimental Mandibular Minipig Model. Clin Oral Implants Res. 2024. PMID: 39387129. doi:10.1111/clr.14369
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。