文献速递牙体牙髓病

三种充填技术对模拟内吸收根管缺损生物陶瓷材料充填质量的三维测量:体外比较研究

Three-Dimensional Measurement of Obturation Quality of Bioceramic Materials in Filling Artificial Internal Root Resorption Cavities Using Different Obturation Techniques: An In Vitro Comparative Study.
PubMed 文献 · J Endod · 2024-04-07

CBCT测量显示BF组总、冠、中、尖POV均显著低于其他组,CWC组根尖POV最高;结论认为CWC、Bio-C Repair及SC法POV最大,优于BF Bio-C Sealer。

要点

  • BF组总、冠、中、尖POV均显著低于SC、BCR+CLC和CWC组(P<.05)。
  • BCR+CLC组根尖POV显著低于SC和CWC组(P<.05)。
  • CWC组根尖POV显著高于其中段(P<.05),BF和BCR+CLC组根尖POV显著低于中段(P<.05)。

核心结论

  • CWC技术、Bio-C Repair及SC法配合Bio-C Sealer可获得最大POV,用于IRR充填优于BF Bio-C Sealer。

研究设计与样本

  • 样本随机分为4组(n=10),分别采用SC、BF、BCR+CLC和CWC充填,CBCT及Mimics Medical软件测量充填前后体积及POV。
  • 统计采用单因素方差分析和Tukey HSD检验,显著性水平P<.05。

主要发现

  • BF组总、冠、中、尖POV值均显著低于SC、BCR+CLC和CWC组(P<.05)。
  • 根尖三分之一处,BCR+CLC组POV显著低于SC和CWC组(P<.05)。
  • 组内比较显示BF和BCR+CLC组根尖POV显著低于中段(P<.05)。
  • CWC组根尖POV显著高于中段(P<.05)。

关键数值与推荐

  • POV为充填体积占根管体积的百分比,通过CBCT和Mimics Medical软件测量。
  • 充填材料包括Bio-C Sealer(SC和BF组)及Bio-C Repair(BCR+CLC组冠中三分之一)。
  • BF组总、冠、中、尖POV均显著低于SC、BCR+CLC和CWC组(P<.05)。
  • BCR+CLC组根尖POV显著低于SC和CWC组(P<.05)。

临床怎么用

  • 对于模拟IRR腔的根管充填,CWC技术、Bio-C Repair及SC法配合Bio-C Sealer可获得更高POV,可能优先于BF Bio-C Sealer。
  • BF Bio-C Sealer在总、冠、中、尖各区域的POV均较低,用于IRR腔充填需谨慎。

局限性

  • 本研究为体外研究,使用拔除牙制备人工IRR腔,结果不能直接等同于临床IRR病例。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

INTRODUCTION: Pathologic conditions such as internal root resorption (IRR) may complicate root canal filling. This study aimed to evaluate and compare the obturation quality by measuring the percentage of obturation volume (POV) in root canals with artificial IRR obturated with different materials and techniques using cone beam computed tomography (CBCT). METHODS: Forty single canal extracted mandibular premolars were decoronated to standardize their length to 14 mm. Following instrumentation, the roots were cut horizontally, and artificial IRR cavities were made at the level of 7 mm from the apex. The root halves were joined using cyanoacrylate adhesive. The samples were randomly assigned to 4 groups (n = 10), and the canals were filled as follows: single-cone technique (SC), bulk-fill Bio-C Sealer (BF), and Bio-C Repair for the coronal and middle third (BCR) + cold lateral condensation technique (CLC) for the apical third and continuous wave compaction technique (CWC). The pre- and postobturation volumes and the POV were measured in the total canal and for the apical, middle, and coronal thirds separately using CBCT and Mimics Medical software. The results were analyzed statistically using one-way ANOVA and Tukey HSD test, and statistical significance was set at P < .05. RESULTS: BF group resulted in significantly lower total, coronal, middle and apical POV values compared to SC, BCR + CLC, and CWC groups (P < .05), respectively. Also, at the apical third, the BCR + CLC group showed significantly lower POV than the SC and CWC groups (P < .05), respectively. The intra-group comparison showed that BF and BCR + CLC groups had a significantly lower POV in the apical third compared to the middle third (P < .05). Conversely, the CWC group had a significantly higher apical POV than the middle third (P < .05). CONCLUSIONS: The maximum POV was obtained using the CWC technique, Bio-C Repair, and SC technique with Bio-C Sealer, making their application in IRR more preferable than the BF Bio-C Sealer.

来源:J Endod,查看原文。版权归原作者所有。

引用

  1. Sharki AM, Ali AH. Three-Dimensional Measurement of Obturation Quality of Bioceramic Materials in Filling Artificial Internal Root Resorption Cavities Using Different Obturation Techniques: An In Vitro Comparative Study. J Endod. 2024. PMID: 38588977. doi:10.1016/j.joen.2024.03.014

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。