文献速递牙体牙髓病儿童口腔

根尖屏障与根管充填材料对未成熟牙应力分布的影响:有限元分析

Effects of Apical Barriers and Root Filling Materials on Stress Distribution in Immature Teeth: Finite Element Analysis Study.
PubMed 文献 · J Endod · 2023-03-23

本研究采用有限元分析,以微CT扫描的未成熟下颌前磨牙为模型,设计6种复合树脂、MTA和Biodentine不同组合的实验模型,施加300 N、135°静态载荷,测量牙根不同层面的von Mises应力。结果显示,复合树脂、MTA或BIO强化根中段时牙本质应力低于牙髓或牙胶组;BIO组各区域平均应力等于或大于MTA组,MTA和BIO均增加周围根牙本质应力,BIO增加更明显。

要点

  • 复合树脂、MTA或BIO强化根中段时,牙根牙本质应力低于牙髓或牙胶组。
  • BIO模型各区域平均von Mises应力等于或大于MTA模型。
  • MTA和BIO均增加周围根牙本质应力,BIO增加程度大于MTA。

核心结论

  • 经根尖诱导成形术治疗的未成熟恒牙,其应力分布受所用材料类型影响。
  • 从力学角度看,MTA是更有利的根尖屏障材料,因其对根尖牙本质产生的应力小于BIO。

研究设计与样本

  • 采用有限元分析(FEA),以微计算机断层扫描(micro-CT)扫描的离体人未成熟下颌前磨牙为参考模型。
  • 设计6种复合树脂、矿物三氧化物凝聚体(MTA)和Biodentine(BIO)不同组合的实验模型。
  • 对每个模型施加与牙体长轴成135°的300 N静态载荷,测量矢状面及根尖8-mm、5-mm、2-mm、1-mm层面的von Mises应力值(MPa)。

主要发现

  • 在所有检查区域,对照(NT)模型牙根应力低于实验模型。
  • 在根中段水平,复合树脂、MTA和BIO强化模型牙根牙本质应力低于牙髓或牙胶模型。
  • BIO模型在所有区域的平均von Mises应力值等于或大于MTA模型。
  • MTA和BIO均导致周围根牙本质应力增加,BIO引起的增加大于MTA。

局限性

  • 原文未述局限性

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

PURPOSE: A finite element analysis (FEA) study was performed to determine whether the material of apical barrier used for root apexification and/or the use of canal reinforcement affect the stress distribution in an endodontically treated immature permanent tooth in order to infer in which clinical scenarios a fracture is more likely to occur based on the ultimate tensile strength threshold of dentin. METHODS AND MATERIALS: An extracted human immature mandibular premolar was selected as the reference model and scanned by micro-computed tomography (micro-CT). The digital model was segmented and converted to STL (Standard Tessellation Language) using Simpleware Scan-IP and exported in IGES (Initial Graphics Exchange Specification) to Ansys 19. Six experimental models were designed with different combinations of composite, mineral trioxide aggregate (MTA), and Biodentine (BIO). Using FEA, a static 300 N load at a 135 angle with respect to the axis of the tooth was applied to each model and von Mises stress values (MPa) were measured at the sagittal, apical 8-mm, 5-mm, 2-mm, and 1-mm levels. RESULTS: In all regions examined, the control (NT model) had lower stress in the root compared WITH experimental models. At the mid-root level, models with composite, MTA, and BIO reinforcement exhibited lower stresses in the root dentin than those with pulp or gutta-percha. BIO models had equal or greater average von Mises stress values than those of MTA models in all regions. Both, MTA and BIO, caused increases in stress of surrounding root dentin, with BIO causing a greater increase than MTA. CONCLUSIONS: Stress distribution in immature permanent teeth treated by apexification is affected by the types of materials used. Root dentin's stress was lower when the mid-root canal was reinforced by composite, MTA, or BIO, which provided similar stress reduction to the root dentin. MTA is a more favorable apical barrier material from a mechanical standpoint because it induces less stress on apical root dentin than BIO.

来源:J Endod,查看原文。版权归原作者所有。

引用

  1. Chun M, Silvestrin T, Savignano R, et al. Effects of Apical Barriers and Root Filling Materials on Stress Distribution in Immature Teeth: Finite Element Analysis Study. J Endod. 2023. PMID: 36965767. doi:10.1016/j.joen.2023.03.009

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。