文献速递口腔修复与种植

混合表面形貌种植体上生物膜形成的体外动态模型研究

Biofilm formation on dental implants with a hybrid surface microtopography: An in vitro study in a validated multispecies dynamic biofilm model.
PubMed 文献 · Clin Oral Implants Res · 2023-03-10

本研究采用经验证的动态多菌种生物膜模型,比较混合表面种植体(HS)上中度粗糙与车削表面形貌对生物膜形成的影响。扫描电镜、共聚焦显微镜和qPCR结果显示,中度粗糙表面在24、48、72小时的细菌生物量和总菌数均显著高于车削表面(p < .05)。

要点

  • 中度粗糙表面在24、48、72小时的细菌生物量均显著高于车削表面(p < .05)。
  • qPCR显示中度粗糙表面在三个时间点的总菌数和特定菌种计数均增加。
  • 种植体表面形貌显著影响体外生物膜结构、生物量和特定菌种数量。

核心结论

  • 种植体表面形貌(中度粗糙 vs 车削)显著影响体外生物膜形成,包括生物膜结构、细菌生物量和模型所选特定菌种的数量。

研究设计与样本

  • 采用经验证的动态体外多菌种生物膜模型,基于流动和剪切条件模拟口腔环境,评估混合表面种植体(HS)上中度粗糙和车削表面的生物膜形成。

主要发现

  • CLSM和SEM显示,在24、48和72小时所有孵育时间点,中度粗糙表面的细菌生物量均显著高于HS种植体的车削表面区域(p < .05)。
  • qPCR分析显示,在三个孵育时间点,中度粗糙表面种植体的总细菌数和特定细菌计数均重要增加。

局限性

  • 原文未述局限性

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

OBJECTIVES: The objective of this study is to qualitatively and quantitatively evaluate biofilm formation on hybrid titanium implants (HS), with moderately rough and turned surface topographies. MATERIALS AND METHODS: A validated dynamic in vitro multispecies biofilm model, based on bacterial growth under flow and shear conditions resembling the oral cavity, was used to evaluate biofilm formation on the tested implant surfaces. Scanning electron microscopy (SEM) and confocal laser scanning microscopy (CLSM) were used to compare the biofilm structure and microbial biomass deposited on either the moderately rough or the turned surface of HS. Quantitative polymerase chain reaction (qPCR) was used to evaluate the total bacterial counts and counts of each specific bacterium in biofilms formed on implants with either the moderately rough or the turned surfaces, as in the hybrid titanium implants, after 24, 48 and 72 h. A general linear model was applied to compare the CLSM and qPCR results between the tested implant surfaces. RESULTS: A significantly higher bacterial biomass grew on the moderately rough implant surfaces, compared to the turned surface area of HS implants (p < .05), at all incubation times, as evidenced with both CLSM and SEM. qPCR analysis also demonstrated an important increase in the total and specific bacterial counts in moderately rough surface implants at the three incubation times. CONCLUSIONS: Implant surface topography (moderately rough versus turned) significantly influenced in vitro biofilm formation in terms of biofilm structure, bacterial biomass and quantity of the specific species selected for the model used.

来源:Clin Oral Implants Res,查看原文。版权归原作者所有。

引用

  1. Bravo E, Serrano B, Ribeiro-Vidal H, et al. Biofilm formation on dental implants with a hybrid surface microtopography: An in vitro study in a validated multispecies dynamic biofilm model. Clin Oral Implants Res. 2023. PMID: 36847713. doi:10.1111/clr.14054

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。