不同咬合负载条件对健康与根管预备磨牙牙根应力分布的影响:有限元分析
本研究通过微计算机断层扫描建立健康与根管预备下颌磨牙有限元模型,分析不同方向咬合力及充填压力对牙根拉应力的影响。结果显示最大牙根应力均位于牙根颈三分之一而非根尖,近中倾斜力使远中根产生拉应力,远中倾斜力使近中根产生拉应力;静态负载下应力小于牙本质疲劳拉伸强度,不导致根尖应力集中。
要点
- 所有负载条件下最高牙根应力均位于牙根颈三分之一,而非根尖区。
- 近中倾斜力使远中根产生拉应力,远中倾斜力使近中根产生拉应力。
- 计算应力小于牙本质疲劳拉伸强度,静态负载不导致根尖应力集中。
核心结论
- 在建模条件下,静态负载不会在牙根根尖产生足以在正常咀嚼负荷下导致牙根折裂的应力集中。
- 近中与远中倾斜力产生的应力模式有助于解释健康未修复磨牙中报告的垂直根折现象。
研究设计与样本
- 基于微计算机断层扫描影像构建健康与根管预备下颌磨牙有限元模型,各组件根据既往文献的力学性能建模。
- 考虑的负载条件包括:指向近中边缘嵴的轴向力、近中或远中倾斜力、扭矩与轴向加载的组合以及流体静压。
主要发现
- 所有负载条件下最高牙根应力均出现在牙根表面颈三分之一处,而非根尖区。
- 近中倾斜力导致远中根产生拉应力,而远中倾斜力导致近中根产生拉应力。
- 根管内压力在牙根颈三分之一的内壁产生拉应力。
- 计算应力小于牙本质的疲劳拉伸强度。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
INTRODUCTION: This study aimed to investigate whether the direction of force applied to the occlusal surface influenced the pattern of tensile stresses in roots of sound and root canal-prepared mandibular molar teeth. The effect of obturation forces on the development of apical stress was also investigated. To this end, models were constructed using micro-computed tomographic imaging and investigated using finite element analysis. METHODS: Micro-computed tomographic data established boundaries of internal and external model surfaces to allow finite element analysis. Individually segmented components were modeled based on mechanical properties in precedent literature. The following conditions were considered: axial force directed over the mesial marginal ridge, a mesial or a distal tipping force, a combination of both a torquing force and axial loading, and hydrostatic pressure. The maximum principal stresses were determined. RESULTS: The highest root stress occurred in the cervical third of root surfaces (ie, not apically) under all loading conditions. Importantly, mesial tipping forces resulted in tension on distal roots, whereas distal tipping resulted in tension in the mesial roots. Intracanal pressures produced tensile stress on the internal root canal walls in the cervical third of the root. Stresses were calculated to be less than the fatigue tensile strength of dentin. CONCLUSIONS: Static loading, under the conditions modeled, does not result in stress concentration at the root apices that would cause root fracture under normal masticatory loads. Stress patterns developing from mesial and distal tipping forces help to explain the appearance of vertical root fractures reported in sound nonrestored molar teeth.
引用
- Wan B, Chung BH, Zhang MR, et al. The Effect of Varying Occlusal Loading Conditions on Stress Distribution in Roots of Sound and Instrumented Molar Teeth: A Finite Element Analysis. J Endod. 2022. PMID: 35405160. doi:10.1016/j.joen.2022.03.009
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。