急性I型夹层修复后近端降主动脉完全重塑的直径变化:对估计夹层前尺寸的启示
本研究纳入60例急性I型夹层术后近端降主动脉假腔完全重塑的患者,回顾术前与重塑后CT,评估基于Rylski因子及形态参数估计夹层前直径的准确性。结果显示重塑后直径较术前减小4.1 mm,等效Rylski因子为15%,单一参数估计误差较大,结合环状夹层范围与双参数可提高可靠性。
要点
- 急性I型夹层术后近端降主动脉完全重塑后直径较术前减小4.1 mm。
- 本组等效Rylski因子为15%,非急性B夹层的23%。
- 单一形态参数估计夹层前直径误差风险高,建议结合环状夹层范围与双参数。
核心结论
- 依赖单一形态参数预测重塑后主动脉直径存在高估和低估的显著风险。
- 基于环状夹层范围并结合真腔最大直径与经Rylski因子校正的面积导出直径,可能提供更可靠的估计。
研究设计与样本
- 回顾性研究,纳入60例急性I型夹层术后近端降主动脉假腔完全重塑的患者,复习术前与重塑后CT。
- 在近端降主动脉测量最大真腔直径(TLDmax)及主动脉面积导出直径除以Rylski因子(AoDRylski)。
主要发现
- 完全重塑后近端降主动脉直径减小4.1 mm(P < 0.001)。
- 本组等效Rylski因子为15%。
- TLDmax和AoDRylski分别有36.7%和48.3%的病例与重塑后主动脉直径差异≥2 mm(P = 0.30)。
- 当两个参数估计值在2 mm内一致时,三分之二的估计准确。
- 环状夹层范围大时AoDRylski更准确,范围小时TLDmax更准确(P = 0.027)。
临床怎么用
- 在急性I型夹层术后评估近端降主动脉尺寸时,不应仅依赖单一形态参数。
- 可结合环状夹层范围,并联合TLDmax与AoDRylski两个参数进行综合估计。
局限性
- 样本量60例,仅纳入近端降主动脉假腔完全重塑者,结论外推需谨慎。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
OBJECTIVES: Pre-dissection diameter of the proximal descending thoracic aorta (p-DTA), if available, would be the reference for determining the size of the stent graft or elephant trunk. Acute type B dissection is known to increase p-DTA diameter by 23% (Rylski factor). This study aimed to investigate the accuracy of estimating post-remodelling diameter of the p-DTA based on the Rylski factor and other post-dissection morphological parameters in acute type I dissection, based on the assumption that the post-remodelling diameter is similar to the pre-dissection diameter. METHODS: In 60 patients with acute type I dissection showing complete remodelling of the p-DTA false lumen after surgical repair, preoperative and post-remodelling computed tomography scans were reviewed. Parameters, including maximal true lumen diameter (TLDmax) and aortic area-derived diameter divided by the Rylski factor (AoDRylski), were measured at the p-DTA. RESULTS: After complete remodelling, p-DTA diameter decreased by 4.1 mm (P < 0.001). The equivalent to the Rylski factor was 15%. Both TLDmax and AoDRylski frequently showed ≥2 mm discrepancy from post-remodelling aortic diameter (36.7% and 48.3%, respectively, P = 0.30). When 2 parameters coincided within 2 mm, two-third of their estimations were accurate. AoDRylski was more accurate than TLDmax in patients with a large extent of circumferential dissection, and vice versa with less circumferential dissection (P = 0.027). CONCLUSIONS: Prediction of post-remodelling aortic diameter relying on a single morphologic parameter carries a substantial risk of overestimation and underestimation. Evaluation based on the extent of circumferential dissection together with the 2 parameters may provide a more reliable estimation.
引用
- Jung JC, Sohn B, Chang HW, et al. Diameter change in completely remodelled proximal descending aorta after acute type I dissection repair: implications for estimating the pre-dissection size. Eur J Cardiothorac Surg. 2021. PMID: 33667303. doi:10.1093/ejcts/ezab096
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。