心脏移植中从微创双心室机械支持转为体外循环的技术
本文介绍一种易于重复的手术技术,用于在心脏移植期间将经皮微创双心室机械支持转换为体外循环。在升主动脉远端置入标准动脉插管后,将ProtekDuo®插管和ProtekSolo®房间隔穿刺插管分别部分回撤至上腔和下腔静脉并连接泵回路进行静脉引流,随后常规完成原位心脏移植并拔除两插管。
要点
- 升主动脉远端置入标准动脉插管建立动脉回流。
- ProtekDuo®与ProtekSolo®插管部分回撤至上、下腔静脉作静脉引流。
- 此体外循环配置下常规完成原位心脏移植并顺利拔管。
核心结论
- 所描述的转换技术易于重复,可在心脏移植中从经皮微创双心室机械支持平稳转为体外循环。
研究设计与样本
- 本文为手术技术描述,未报告研究设计与样本量。
主要发现
- 升主动脉远端置入标准动脉插管后,将ProtekDuo®插管和ProtekSolo®房间隔穿刺插管分别部分回撤至上腔和下腔静脉并连接泵回路进行静脉引流。
- 在该体外循环配置下常规完成原位心脏移植,术毕两插管顺利拔除。
临床怎么用
- 对于经皮微创双心室机械支持患者,心脏移植时可参照此插管回撤与连接方式建立体外循环。
局限性
- 原文未报告样本量、结局数据及局限性分析。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
An easily reproducible surgical technique to switch from percutaneous minimally invasive biventricular mechanical support to cardiopulmonary bypass during heart transplantation is illustrated. After cannulation of the distal ascending aorta with a standard arterial cannula, the ProtekDuo® cannula and the ProtekSolo® Transseptal cannula were partially retracted to reach the superior and inferior vena cava, respectively, and connected to the pump circuit for the venous drainage. With this cardiopulmonary bypass configuration, orthotopic heart transplantation was routinely performed and, at the end of the procedure, the 2 cannulas were uneventfully removed.
引用
- Settepani F, Marianeschi SM, Costetti A, et al. Switch from minimally invasive biventricular mechanical support to cardiopulmonary bypass during heart transplant. Eur J Cardiothorac Surg. 2021. PMID: 32944739. doi:10.1093/ejcts/ezaa343
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。