升主动脉瘤血流动力学与主动脉壁生物力学特性相关
研究对5例升主动脉瘤患者术前行磁共振血管成像和四维磁共振成像,构建血流动力学模型估算最大壁面剪切应力等指标,并对切除的主动脉样本行双轴拉伸和剥离测试,分析血流动力学指标与生物力学特性的相关性。结果显示最大壁面剪切应力与纵向能量损失及各向异性指数正相关,平均振荡剪切指数与剥离强度正相关,血流动力学指标或可为评估主动脉壁完整性提供新思路。
要点
- 最大壁面剪切应力与纵向能量损失(rs=0.75,P=0.002)及各向异性指数(rs=0.68,P=0.01)正相关。
- 最大时间平均壁面剪切应力与纵向能量损失(rs=0.73,P=0.003)及各向异性指数(rs=0.62,P=0.02)正相关。
- 平均振荡剪切指数与剥离强度正相关(rs=0.73,P=0.04)。
核心结论
- 升主动脉瘤壁面剪切力与局部动脉壁黏弹性滞后(ΔUL)和剥离强度(主动脉夹层的替代指标)相关。
- 血流动力学指标可能为评估主动脉壁完整性提供见解,最终形成评估升主动脉瘤相关风险的新指标。
研究设计与样本
- 研究纳入5例升主动脉瘤患者,术前行磁共振血管成像和四维磁共振成像,构建血流动力学模型估算最大壁面剪切应力、最大时间平均壁面剪切应力、平均振荡剪切指数和平均相对停留时间。
- 14份切除的主动脉样本行双轴拉伸测试,测定纵向和环向的能量损失(ΔULlong、ΔULcirc)和弹性模量(E10long、E10circ)及各参数的各向异性指数(AI)。
- 9份切除的主动脉样本行剥离测试测定剥离强度(Sd),并将血流动力学指标与生物力学特性进行相关性分析。
主要发现
- 最大壁面剪切应力与ΔULlong呈正相关(rs=0.75,P=0.002),与AIΔUL呈正相关(rs=0.68,P=0.01)。
- 最大时间平均壁面剪切应力增加与ΔULlong增加相关(rs=0.73,P=0.003),与AIΔUL增加相关(rs=0.62,P=0.02)。
- 平均振荡剪切指数与Sd呈正相关(rs=0.73,P=0.04)。
- 任何血流动力学指标与E10之间、相对停留时间与任何生物力学特性之间均未发现显著关系。
局限性
- 原文未报告局限性
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
OBJECTIVES: The effect of aortic haemodynamics on arterial wall properties in ascending thoracic aortic aneurysms (ATAAs) is not well understood. We aim to delineate the relationship between shear forces along the aortic wall and loco-regional biomechanical properties associated with the risk of aortic dissection. METHODS: Five patients with ATAA underwent preoperative magnetic resonance angiogram and four-dimensional magnetic resonance imaging. From these scans, haemodynamic models were constructed to estimate maximum wall shear stress (WSS), maximum time-averaged WSS, average oscillating shear index and average relative residence time. Fourteen resected aortic samples from these patients underwent bi-axial tensile testing to determine energy loss (ΔUL) and elastic modulus (E10) in the longitudinal (ΔULlong, E10long) and circumferential (ΔULcirc, E10circ) directions and the anisotropic index (AI) for each parameter. Nine resected aortic samples underwent peel testing to determine the delamination strength (Sd). Haemodynamic indices were then correlated to the biomechanical properties. RESULTS: A positive correlation was found between maximum WSS and ΔULlong rs=0.75, P = 0.002 and AIΔUL (rs=0.68, P=0.01). Increasing maximum time-averaged WSS was found to be associated with increasing ΔULlong (rs=0.73, P = 0.003) and AIΔUL (rs=0.62, P=0.02). Average oscillating shear index positively correlated with Sd (rs=0.73,P=0.04). No significant relationship was found between any haemodynamic index and E10, or between relative residence time and any biomechanical property. CONCLUSIONS: Shear forces at the wall of ATAAs are associated with local degradation of arterial wall viscoelastic hysteresis (ΔUL) and delamination strength, a surrogate for aortic dissection. Haemodynamic indices may provide insights into aortic wall integrity, ultimately leading to novel metrics for assessing risks associated with ATAAs.
引用
- McClarty D, Ouzounian M, Tang M, et al. Ascending aortic aneurysm haemodynamics are associated with aortic wall biomechanical properties. Eur J Cardiothorac Surg. 2022. PMID: 34718497. doi:10.1093/ejcts/ezab471
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。