文献速递呼吸衰竭与机械通气重症综合管理与镇静镇痛

有创机械通气动态内源性呼气末正压估算方法的理论研究

[A theoretical study on a method for estimating dynamic intrinsic positive end-expiratory pressure in invasive mechanical ventilation].
PubMed 文献 · Zhonghua Wei Zhong Bing Ji Jiu Yi Xue · 2024-01-01
一句话结论对呼气气流不完全的有创通气患者,呼气流量-时间曲线延伸法理论上可实时估算动态内源性呼气末正压。

该研究以2020年9月东营市人民医院重症医学科一例因头胸部创伤致呼吸衰竭行有创机械通气的60岁男性患者为对象,其治疗期间出现呼气气流不完全,以该患者的呼气流量-时间曲线为研究对象。研究设定T0为呼气开始、T1为吸气动作开始前、T2为吸气驱动使呼气流量降至零、T3为按T1前自然呼气曲线趋势延伸至呼气流量为零的时间点,将T1点肺内压定义为PEEPi1、T2点假设去除吸气动力后的肺内压定义为PEEPi2(等于T3点呼吸机设定的PEEP)。镇静后在容量控制通气模式下选取约1/3潮气量,用吸气暂停法测得呼吸系统静态顺应性C,按C=ΔV/ΔP公式推导出PEEPi1=PEEP+(S3-S1)/C、PEEPi2=PEEP+(S3-S2)/C。作者认为,对呼气不完全的有创通气患者,呼气流量-时间曲线延伸法理论上可用于实时估算动态PEEPi。该估算方法已获中国国家发明专利(ZL 2020 1 0391736.1)。

要点

  • 研究对象为2020年9月东营市人民医院重症医学科一例60岁男性,因头胸部创伤致呼吸衰竭行有创机械通气,治疗期间出现呼气气流不完全。
  • 以呼气流量-时间曲线为对象:T0为呼气开始,T1为吸气动作开始前,T2为吸气驱动使呼气流量降至零,T3为按T1前自然呼气曲线趋势延伸至呼气流量为零的时间点。
  • T1点肺内压称PEEPi1,T2点假设去除吸气动力后的肺内压称PEEPi2,PEEPi2等于T3点呼吸机设定的PEEP。
  • 镇静后容量控制通气模式下选取约1/3潮气量,用吸气暂停法测呼吸系统静态顺应性C,按C=ΔV/ΔP推导:PEEPi1=PEEP+(S3-S1)/C,PEEPi2=PEEP+(S3-S2)/C。
  • 作者认为,对呼气不完全的有创机械通气患者,呼气流量-时间曲线延伸法理论上可实时估算动态PEEPi。

适用人群与场景

  • 有创机械通气治疗呼吸衰竭、治疗期间出现呼气气流不完全的患者,研究对象为2020年9月东营市人民医院重症医学科一例60岁男性头胸部创伤患者。

诊断标准与关键阈值

  • 以呼气流量-时间曲线分期:T0为呼气开始时间,T1为吸气动作(吸气用力)开始前的时间,T2为吸气驱动(吸气用力持续)使呼气流量降至零的时间。
  • 以T1为起点按T1点前自然呼气曲线趋势延伸至呼气流量为0的时间点为T3点。
  • T1点(刚由呼气转为吸气时)肺内压称PEEPi1;T2点(呼气流量降至0时)假设去除吸气动力后的肺内压称PEEPi2,等于T3点呼吸机设定的PEEP。
  • T0至T1呼气流量-时间曲线下面积(呼出气量)为S1,T0至T2为S2,T0至T3为S3。

处置流程与药物剂量

  • 镇静后,在容量控制通气模式下选取约1/3潮气量,用吸气暂停法测量患者呼吸系统静态顺应性C。
  • 按公式C=ΔV/ΔP计算,ΔV为一定时间内肺泡容积变化,ΔP为同一时间段肺内压变化。
  • PEEPi1计算:T1至T3呼出气量跨度为S3-S1、肺内压下降跨度为PEEPi1-PEEP,故C=(S3-S1)/(PEEPi1-PEEP),PEEPi1=PEEP+(S3-S1)/C。
  • PEEPi2计算:T2至T3呼出气量跨度为S3-S2、肺内压下降跨度为PEEPi2-PEEP,故C=(S3-S2)/(PEEPi2-PEEP),PEEPi2=PEEP+(S3-S2)/C。

证据类型、等级与局限

  • 理论研究,以单例患者的呼气流量-时间曲线为研究对象,未报告样本量与效应量。
  • 该估算方法已获中国国家发明专利(ZL 2020 1 0391736.1)。
  • 局限:原文未报告局限性。

对床旁实践的改变

  • 作者认为,对有创机械通气期间呼气不完全的患者,呼气流量-时间曲线延伸法理论上可用于实时估算动态PEEPi。

提炼说明

  • 本条依据论文摘要整理;摘要未涉及「红旗征与不能漏的情况」「研究设计与关键结果」「指南或共识出处」,故未列出这些栏目;全文请点「阅读原文」。
英文原文(摘要)· 点击展开

OBJECTIVE: To explore a simple method for measuring the dynamic intrinsic positive end-expiratory pressure (PEEPi) during invasive mechanical ventilation.

METHODS: A 60-year-old male patient was admitted to the critical care medicine department of Dongying People's Hospital in September 2020. He underwent invasive mechanical ventilation treatment for respiratory failure due to head and chest trauma, and incomplete expiratory flow occurred during the treatment. The expiratory flow-time curve of this patient was served as the research object. The expiratory flow-time curve of the patient was observed, the start time of exhalation was taken as T0, the time before the initiation of inspiratory action (inspiratory force) was taken as T1, and the time when expiratory flow was reduced to zero by inspiratory drive (inspiratory force continued) was taken as T2. Taking T1 as the starting point, the follow-up tracing line was drawn according to the evolution trending of the natural expiratory curve before the T1 point, until the expiratory flow reached to 0, which was called T3 point. According to the time phase, the intrapulmonary pressure at the time just from expiratory to inspiratory (T1 point) was called PEEPi1. When the expiratory flow was reduced to 0 (T2 point), the intrapulmonary pressure with the inhaling power being removed hypothetically was called PEEPi2. And it was equal to positive end-expiratory pressure (PEEP) set in the ventilator at T3 point. The area under the expiratory flow-time curve (expiratory volume) between T0 and T1 was called S1. And it was S2 between T0 and T2, S3 between T0 and T3. After sedation, in the volume controlled ventilation mode, approximately one-third of the tidal volume was selected, and the static compliance of patient's respiratory system called "C" was measured using the inspiratory pause method. PEEPi1 and PEEP2 were calculated according to the formula "C = ΔV/ΔP". Here, ΔV was the change in alveolar volume during a certain period of time, and ΔP represented the change in intrapulmonary pressure during the same time period. This estimation method had obtained a National Invention Patent of China (ZL 2020 1 0391736.1).

RESULTS: (1) PEEPi1: according to the formula "C = ΔV/ΔP", the expiratory volume span from T1 to T3 was "S3-S1", and the intrapulmonary pressure decreased span was "PEEPi1-PEEP". So, C = (S3-S1)/(PEEPi1-PEEP), PEEPi1 = PEEP+(S3-S1)/C. (2)PEEPi2: the expiratory volume span from T2 to T3 was "S3-S2", and the intrapulmonary pressure decreased span was "PEEPi2-PEEP". So, C = (S3-S2)/(PEEPi2-PEEP), PEEPi2 = PEEP+(S3-S2)/C.

CONCLUSIONS: For patients with incomplete expiratory during invasive mechanical ventilation, the expiratory flow-time curve extension method can theoretically be used to estimate the dynamic PEEPi in real time.

来源:Zhonghua Wei Zhong Bing Ji Jiu Yi Xue,查看原文。版权归原作者所有。

参考来源

  1. Wu Y, Liu X. [A theoretical study on a method for estimating dynamic intrinsic positive end-expiratory pressure in invasive mechanical ventilation]. Zhonghua Wei Zhong Bing Ji Jiu Yi Xue. 2024. PMID: 38404279. doi:10.3760/cma.j.cn121430-20230608-00429

供执业医师抢救与诊疗参考,不替代临床判断;剂量请结合体重、肝肾功能和本院药品规格复核,以指南原文为准。