文献速递呼吸衰竭与机械通气重症综合管理与镇静镇痛

机械功率在压力控制通气和不同容量控制通气模式间的差异

Mechanical Power Differs Between Pressure-Controlled Ventilation and Different Volume-Controlled Ventilation Modes.
PubMed 文献 · Crit Care Explor · 2022-08-15
一句话结论控制通气患者中,无暂停时间容量控制通气机械功率最低(19.30 J/min),压力控制通气居中(20.87 J/min),10%暂停时间容量控制通气最高(21.80 J/min)。

该概念验证研究在单中心ICU纳入46例无自主呼吸努力的控制通气患者(共58例次),基线在压力控制通气下测量,随后在潮气量和其他设置不变条件下测量容量控制通气无暂停时间(VCV-0)和10%暂停时间(VCV-10)。结果显示VCV-0、VCV-10和PCV的平均机械功率分别为19.30、21.80和20.87 J/min(所有比较p<0.05),跨肺机械功率分别为6.75、8.60和7.99 J/min(所有比较p<0.05)。提示同一患者在不同通气模式下机械功率存在差异,VCV-0最低,VCV-10最高。

要点

  • 无自主呼吸努力的控制通气患者中,VCV-0平均机械功率19.30 J/min,低于PCV的20.87 J/min(p<0.05)。
  • VCV-10平均机械功率21.80 J/min,高于PCV的20.87 J/min和VCV-0的19.30 J/min(p<0.05)。
  • 跨肺机械功率VCV-0为6.75 J/min、VCV-10为8.60 J/min、PCV为7.99 J/min,所有比较p<0.05。
  • 潮气量和其他设置保持不变时,仅切换模式即可使机械功率发生差异,VCV-0最低、VCV-10最高。

适用人群与场景

  • ICU内接受控制通气、无自主呼吸努力的患者,共46例、58例次。

研究设计与关键结果

  • 概念验证研究,单中心大学医学中心ICU,纳入46例无自主呼吸努力的控制通气患者共58例次;基线在压力控制通气下测量,随后在潮气量和其他设置不变条件下测量VCV-0和VCV-10。
  • 平均机械功率:VCV-0为19.30 J/min、VCV-10为21.80 J/min、PCV为20.87 J/min,所有比较p<0.05。
  • 跨肺机械功率:VCV-0为6.75 J/min、VCV-10为8.60 J/min、PCV为7.99 J/min,所有比较p<0.05。

证据类型、等级与局限

  • 证据类型:概念验证研究。
  • 局限:原文未报告局限性。

对床旁实践的改变

  • 在无自主呼吸努力的控制通气患者中,选择VCV-0而非VCV-10可降低机械功率(19.30 vs 21.80 J/min,p<0.05),选择PCV时机械功率介于两者之间(20.87 J/min)。

提炼说明

  • 本条依据论文摘要整理;摘要未涉及「诊断标准与关键阈值」「处置流程与药物剂量」「红旗征与不能漏的情况」「指南或共识出处」,故未列出这些栏目;全文请点「阅读原文」。
英文原文(摘要)· 点击展开

OBJECTIVES: Mechanical power (MP) is a way of estimating the energy delivered by the ventilator to the patient. For both volume-controlled ventilation (VCV) and pressure-controlled ventilation (PCV) methods have been described to calculate the MP. The pressure-volume (PV) loop, from which the MP is calculated, is different for VCV compared with PCV. We aimed to compare the MP of VCV with zero pause time (VCV-0), VCV with 10% pause time (VCV-10), and PCV within patients in different patient categories based on severity of lung injury.

DESIGN: In a proof-of-concept study, we enrolled 46 mechanically ventilated patients without spontaneous breathing efforts. Baseline measurements were done in pressure-controlled mode. Subsequently, measurements were done in VCV-0 and VCV-10. Tidal volume and all other settings were kept the same.

SETTING: ICU, single university medical center.

PATIENTS: Fifty-eight cases in 46 patients on controlled ventilation modes.

INTERVENTIONS: Comparison between the MP of PCV, VCV-0, and VCV-10.

MEASUREMENT AND MAIN RESULTS: The mean MP of VCV-0, VCV-10, and PCV was 19.30, 21.80, and 20.87 J/min, respectively (p < 0.05 for all comparisons). The transpulmonary MP of VCV-0, VCV-10, and PCV was 6.75, 8.60, and 7.99 J/min, respectively (p < 0.05 for all comparisons).

CONCLUSIONS: In patients ventilated in a controlled mode, VCV without pause time had the lowest MP followed by PCV. VCV with 10% pause time had the highest MP.

来源:Crit Care Explor,查看原文。版权归原作者所有。

参考来源

  1. Rietveld PJ, Snoep JWM, Lamping M, et al. Mechanical Power Differs Between Pressure-Controlled Ventilation and Different Volume-Controlled Ventilation Modes. Crit Care Explor. 2022. PMID: 35982836. doi:10.1097/CCE.0000000000000741

供执业医师抢救与诊疗参考,不替代临床判断;剂量请结合体重、肝肾功能和本院药品规格复核,以指南原文为准。