文献速递肺结节与肺癌

CT肺癌筛查中肺结节直径与体积测量不一致

Disagreement of diameter and volume measurements for pulmonary nodule size estimation in CT lung cancer screening.
PubMed 文献 · Thorax · 2017-10-22

研究纳入2240个不确定实性结节(体积50-500mm³),比较直径与半自动体积测量的相关性。结节内直径变异中位数2.8mm(IQR 2.2-3.7mm),超过Lung-RADS的1.5mm生长阈值;用平均或最大轴位直径评估体积分别平均高估47.2%和85.1%。

要点

  • 结节内直径变异中位数2.8mm,超过Lung-RADS的1.5mm生长阈值。
  • 平均直径较半自动体积平均高估结节体积47.2%。
  • 最大轴位直径较半自动体积平均高估结节体积85.1%。

核心结论

  • 不确定结节的直径测量不能准确代表其体积大小。

研究设计与样本

  • 研究纳入2240个不确定实性结节,结节体积为50-500mm³,比较直径与半自动体积测量。

主要发现

  • 结节内直径变异(通过结节中心的最大径减最小径)中位数为2.8mm(IQR 2.2-3.7mm)。
  • 使用平均轴位直径评估体积较半自动体积平均高估47.2%。
  • 使用最大轴位直径评估体积较半自动体积平均高估85.1%。

关键数值与推荐

  • 结节内直径变异中位数2.8mm,高于Lung-RADS用于结节生长的1.5mm cutoff。

临床怎么用

  • 在肺癌筛查中评估不确定实性结节时,应优先采用半自动体积测量而非直径。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

UNLABELLED: We studied 2240 indeterminate solid nodules (volume 50-500mm3) to determine the correlation of diameter and semi-automated volume measurements for pulmonary nodule size estimation. Intra-nodular diameter variation, defined as maximum minus minimum diameter through the nodule's center, varied by 2.8 mm (median, IQR:2.2-3.7 mm), so above the 1.5 mm cutoff for nodule growth used in Lung CT Screening Reporting and Data System (Lung-RADS). Using mean or maximum axial diameter to assess nodule volume led to a substantial mean overestimation of nodule volume of 47.2% and 85.1%, respectively, compared to semi-automated volume. Thus, size of indeterminate nodules is poorly represented by diameter. TRIAL REGISTRATION NUMBER: Pre-results, ISRCTN63545820.

来源:Thorax,查看原文。版权归原作者所有。

引用

  1. Heuvelmans MA, Walter JE, Vliegenthart R, et al. Disagreement of diameter and volume measurements for pulmonary nodule size estimation in CT lung cancer screening. Thorax. 2017. PMID: 29056601. doi:10.1136/thoraxjnl-2017-210770

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。