输卵管镜输卵管成形术:一种简便、快速且安全的技术
本文描述了一种简化的输卵管镜输卵管成形术(FT)技术,并利用黏土模型演示其原理。研究纳入2013年10月至2019年2月间431例单侧或双侧近端输卵管阻塞(距子宫输卵管口6 cm)的不孕女性,由10名医生在私立不孕诊所实施。平均手术时间15.4分钟,临床妊娠率24.4%(自然受孕及未行体外受精的宫内授精),医生间手术时间和妊娠率无显著差异。结论认为该简化技术可行且实用,通过节省纤维镜具有优良的成本效益。
要点
- 关键技术点:不直视下将球囊和纤维镜插入距子宫输卵管口5-10 mm处。
- 平均手术时间15.4分钟,临床妊娠率24.4%(自然受孕及未行IVF的IUI)。
- 医生间手术时间和妊娠率无显著差异,一根纤维镜约可完成17次FT手术。
核心结论
- 简化FT技术可行且实用,通过节省纤维镜具有优良的成本效益。
研究设计与样本
- 技术描述与黏土模型原理演示,并报告2013年10月至2019年2月431例不孕女性的临床应用结果。
主要发现
- 平均手术时间15.4分钟,临床妊娠率24.4%(自然受孕及未行体外受精的宫内授精)。
- 医生间手术时间和妊娠率无显著差异。
- 一根纤维镜约可完成17次FT手术。
关键数值与推荐
- 关键技术:不直视下将球囊和纤维镜插入距子宫输卵管口5-10 mm处。
- 球囊压力调整顺序为6→8→6→10→6 mmHg。
- 建议先观看视频,再在不寻找子宫输卵管口的情况下练习FT;医生在≤3次尝试内无需指导者协助即可掌握。
临床怎么用
- 可作为一种简便、快速且安全的近端输卵管阻塞处理方法,适合在门诊开展。
- 通过规范操作和视频学习可缩短学习曲线,节省纤维镜使用成本。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
OBJECTIVE: To describe our simplified technique for falloposcopic tuboplasty (FT) and demonstrate its principle and results. DESIGN: A step-by-step description of the technique and demonstration of its principle using a clay model. SETTING: Private infertility clinics in Osaka and Tokyo operated by 10 physicians. PATIENT(S): A total of 431 infertile women with a diagnosis of unilateral or bilateral proximal tubal occlusion (6 cm from the uterotubal ostia), between October 2013 and February 2019 were included. These patients underwent routine work-ups for infertility, including a semen analysis, hysterosalpingography, antimüllerian hormone, basal luteinizing hormone/follicle-stimulating hormone and prolactin concentrations during menstruation, postcoital test in the periovulatory period, and estradiol and progesterone concentrations in the middle of the luteal phase. Physicians performed hysterosalpingography to evaluate tubal patency and uterine shape. Saline infusion sonography was not conducted because it does not accurately identify regions of tubal occlusion and/or stenosis. INTERVENTION(S): The principle of our simplified technique for FT is that a hole is located at the side of the FT catheter tip. Therefore, the balloon and fiberscope move away from the catheter line (Fig. 1). The uterotubal ostium is located at the tip-end of the triangle of the uterine cavity. When a balloon is inserted while visualizing the uterotubal ostium at the nearest position to the ostium, the balloon hits the uterine wall. When a balloon is inserted 5-10 mm from the uterotubal ostium without visualization, the balloon may be easily placed in the ostium through its convex angle, allowing it to slide into the uterine wall (Figs. 2 and 3). Step 1: Confirm anteflexion or retroflexion of the uterus by ultrasound. Step 2: Confirm the direction of the uterotubal ostia by hysteroscopy. Step 3: Adjust the angle of the FT catheter according to steps 1 and 2, insert the catheter into the end of the uterus, pull it back 5-10 mm (without visualizing the uterotubal ostia), and then fix it to the forceps. Catheter placement away from the tubal ostium is confirmed by the residual length of the moving part of the catheter. An attending instructor should ask the operator about the feeling of rigidity when the catheter does not advance and then suggest whether to proceed or stop. In the latter case, the catheter is not moved, saline is infused for 1 minute for lubrication, the balloon is pulled back using the fiberscope to remove the bunching of the balloon, and balloon pressure is changed as follows: 6→8→6→10→6 mmHg. Our institutional review board stated that approval was not required because the video describes the technique of our routine procedure. MAIN OUTCOME MEASURE(S): A description of the FT technique using a clay model and a demonstration of its application in our clinic. RESULT(S): The average operative time was 15.4 minutes, and the clinical pregnancy rate was 24.4% (natural conception and intrauterine insemination without in vitro fertilization). No significant differences were observed in the operative time or pregnancy rate among physicians. Approximately 17 FT procedures may be performed using one fiberscope. CONCLUSION(S): Our simplified technique, which was described and demonstrated in this video article, is a feasible and practical approach for performing FT. It provides excellent cost performance by saving fiberscopes. The most important point is "Introduce the balloon and fiberscope 5-10 mm away from the uterotubal ostia without visualizing it." To facilitate learning this technique, we recommend watching the video and then practicing FT without searching for the uterotubal ostia. Physicians master FT without any assistance by an attending instructor in ≤3 attempts.
引用
- Matsubayashi H, Takaya Y, Takeuchi T, et al. Falloposcopic tuboplasty: an easy, quick, and safe technique. Fertil Steril. 2021. PMID: 34535295. doi:10.1016/j.fertnstert.2021.08.019
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。