文献速递生殖医学

胚胎移植培养基黏度估算及其与子宫液相互作用的考量

Estimation of embryo transfer media viscosity and consideration of its effect on media and uterine fluid interactions.
PubMed 文献 · Reprod Biomed Online · 2019-07-29

研究采用腔室载玻片填充时间法估算多种商业及自制改良胚胎移植培养基的黏度,每种培养基12或24个重复,在标准操作温度与气体平衡条件下测量。结果显示完全培养基黏度估计为1.15-1.77 cP,完全移植培养基EmbryoGlue和UTM分别为3.59 cP和1.28 cP,水为1.06 cP。结论指出移植培养基黏度分布较窄,但与假设的子宫液黏度(1000 cP)差异巨大。

要点

  • 完全培养基黏度估计为1.15-1.77 cP,完全移植培养基EmbryoGlue为3.59 cP、UTM为1.28 cP。
  • Global HEPES添加10%-50% SSS后黏度估计为1.16-1.34 cP,水为1.06 cP。
  • 移植培养基黏度与假设的子宫液黏度(1000 cP)差异巨大。

核心结论

  • 多种商业或自制改良移植培养基的黏度分布相对较窄,但与假设的子宫液黏度(1000 cP)存在巨大差异。

研究设计与样本

  • 采用腔室载玻片填充时间(秒)计算每种商业及自制改良培养基的黏度,每种培养基12或24个重复,在胚胎移植标准操作温度与气体平衡条件下进行。
  • 计算均值、标准差和变异系数,并使用回归方程估算每种培养基的黏度,以比较为目的呈现。

主要发现

  • 完全培养基G1-Plus、G2-Plus、G-TL、1-Step、Global Total、Global Total HEPES和Sperm Wash Medium的黏度估计分别为1.65 cP、1.77 cP、1.68 cP、1.29 cP、1.18 cP、1.15 cP和1.20 cP。
  • 完全移植培养基EmbryoGlue和UTM的黏度估计分别为3.59 cP和1.28 cP。
  • Global HEPES培养基添加10%、20%、30%和50%(体积比)合成血清替代物(SSS)的黏度估计分别为1.16 cP、1.23 cP、1.25 cP和1.34 cP。
  • 作为参考,水的黏度估计为1.06 cP。

关键数值与推荐

  • 完全培养基G1-Plus、G2-Plus、G-TL、1-Step、Global Total、Global Total HEPES和Sperm Wash Medium的黏度估计分别为1.65 cP、1.77 cP、1.68 cP、1.29 cP、1.18 cP、1.15 cP和1.20 cP。
  • 完全移植培养基EmbryoGlue和UTM的黏度估计分别为3.59 cP和1.28 cP。
  • Global HEPES培养基添加10%、20%、30%和50%(体积比)SSS的黏度估计分别为1.16 cP、1.23 cP、1.25 cP和1.34 cP。
  • 水的黏度估计为1.06 cP。
  • 假设的子宫液黏度为1000 cP。

临床怎么用

  • 当代胚胎移植培养基可能很适合IVF,但评估所有变量(如移植背景下的培养基黏度)可增加从业者应具备的知识基础。

局限性

  • 原文未述局限性

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

RESEARCH QUESTION: What are the viscosities of media used for human embryo transfer and what is the possible effect of viscosity as it relates to interactions between transfer media and uterine fluid. DESIGN: Chamber slide filling times, in seconds, were used to calculate viscosity for each commercial and in-house modified medium, with 12 or 24 replicates per medium under standard operating procedure temperature and gas equilibration conditions used for embryo transfer. Means, standard deviations and coefficients of variation were calculated, and each viscosity was estimated using a regression equation; viscosities for each medium were presented for comparative purposes. RESULTS: Complete culture media (G1-Plus, G2-Plus, G-TL, 1-Step, Global Total, Global Total HEPES, and Sperm Wash Medium) had viscosity estimates of 1.65 cP, 1.77 cP, 1.68 cP, 1.29cP, 1.18 cP, 1.15 cP, and 1.20 cP, respectively. Complete transfer media (EmbryoGlue, UTM), had viscosity estimates of 3.59 cP and 1.28 cP, respectively. Global HEPES medium with 10%, 20%, 30%, and 50% synthetic serum substitute (SSS) volume per volume had viscosity estimates 1.16 cP, 1.23 cP, 1.25 cP, and 1.34 cP, respectively. For reference, water had a viscosity estimate of 1.06 cP. CONCLUSIONS: A relatively narrow distribution of viscosities was observed across several transfer media despite the various commercial or in-house modifications. These data demonstrate the vast difference between viscosities of embryo transfer media and the assumed viscosity of uterine fluid (1000 cP). Contemporary embryo transfer media may be well-suited for IVF, but evaluation of all variables, e.g. media viscosity in the context of embryo transfer, adds to the knowledge base that should be available to practitioners.

来源:Reprod Biomed Online,查看原文。版权归原作者所有。

引用

  1. Reed ML, Said AH. Estimation of embryo transfer media viscosity and consideration of its effect on media and uterine fluid interactions. Reprod Biomed Online. 2019. PMID: 31677922. doi:10.1016/j.rbmo.2019.07.034

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。