玻璃化冷冻/复温后囊胚形态动力学分析:定义新的种植预测变量
该观察性回顾性队列研究在大学附属私立体外受精中心纳入429枚已知种植结局的玻璃化冷冻/复温囊胚,用延时成像评估复温后形态动力学。复温后再扩张囊胚种植率为44.6%,未再扩张者为6.5%;逻辑回归显示囊胚最大面积(OR=0.41,95%CI 0.22-0.77)和初始面积(OR=0.62,95%CI 0.35-1.08)是最具预测力的变量,囊胚形态学分类未被视为相关。作者据此提出将复温囊胚分为A至D四类的层级模型,预期种植潜能从A类的47.3%降至D类的14.2%。
要点
- 复温后再扩张囊胚种植率44.6%,未再扩张者6.5%。
- 囊胚最大面积OR=0.41(95%CI 0.22-0.77)与种植相关。
- 作者提出的A至D层级模型预期种植潜能从47.3%降至14.2%。
核心结论
- 延时成像分析复温囊胚可能提供囊胚种植潜能的客观定量标志物。
- 作者提出按种植概率对玻璃化冷冻/复温囊胚分类的层级模型。
- 作者指出观察到的相关性和所提算法应在前瞻性试验中验证以评估其效能。
研究设计与样本
- 观察性、回顾性队列研究,在大学附属私立体外受精中心开展。
- 纳入429枚已知种植数据的玻璃化冷冻/复温囊胚,复温后立即置入EmbryoScope(Vitrolife)行延时成像至移植。
- 胚胎采用Cryotop法(KitazatoBiopharma)玻璃化冷冻与复温。
- 研究变量包括透明带初始与最小厚度(μm)、初始与最大面积(μm2)、内细胞团面积(μm2)、复温后是否再扩张、复温后塌陷或收缩。
- 按种植概率最高的连续四分位数确定最佳范围后,将上述变量与西班牙胚胎学家协会囊胚形态学分类标准(A、B、C、D类)结合进行逻辑回归分析。
主要发现
- 复温后再扩张囊胚种植率为44.6%,未再扩张者为6.5%。
- 逻辑回归模型中最大囊胚面积OR=0.41(95%CI 0.22-0.77),其次为初始面积OR=0.62(95%CI 0.35-1.08)。
- 囊胚形态学在本模型中未被视为相关。
- 层级树模型将胚胎分为A至D四类,预期种植潜能从A类的47.3%降至D类的14.2%。
关键数值与推荐
- 复温后再扩张囊胚种植率44.6% vs 未再扩张囊胚6.5%。
- 最大囊胚面积OR=0.41(95%CI 0.22-0.77)。
- 初始面积OR=0.62(95%CI 0.35-1.08)。
- 层级模型A类预期种植潜能47.3%,D类14.2%。
临床怎么用
- 作者提出用延时成像分析复温囊胚的定量形态学标志物以评估种植潜能。
- 作者提出按种植概率对玻璃化冷冻/复温囊胚分层的层级模型。
- 作者认为观察到的相关性和所提算法应在前瞻性试验中验证其效能。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
OBJECTIVE: To describe the morphological dynamics of vitrified/warmed blastocysts and to identify quantitative morphological variables related to implantation. Subsequently, by using the most predictive parameters, to develop a hierarchical model by subdividing vitrified/warmed blastocysts into categories with different implantation potentials. DESIGN: Observational, retrospective, cohort study. SETTING: University-affiliated private IVF center. PATIENT(S): The study included 429 vitrified/warmed blastocysts with known implantation data, which were evaluated by time-lapse imaging. Blastocysts were routinely placed in EmbryoScope (Vitrolife) immediately after warming until transfer. INTERVENTION(S): None. MAIN OUTCOME MEASURE(S): Embryos were vitrified and warmed by the Cryotop method (KitazatoBiopharma). The studied variables included the initial and minimum thicknesses of zona pellucida (μm), the initial and maximum areas (μm2), the area of inner cell mass (μm2), expansion (whether the embryo reexpands or not after warming), and collapsing or contraction after warming. After defining the optimal ranges according to the consecutive quartiles with the highest probability of implantation, a logistic regression analysis was performed by combining the former variables and the blastocyst morphological classification criteria defined by the Spanish Association of Embryologists into A, B, C, or D categories. RESULT(S): Reexpansion of vitrified/warmed blastocysts correlated strongly with implantation (44.6% for reexpanded vs. 6.5% for the blastocysts that did not reexpand after warming). Throughout the logistic regression analysis, the model identified the maximum blastocyst area, odds ratio (OR) = 0.41 (95% confidence interval [CI], 0.22-0.77), followed by the initial area, OR = 0.62 (95% CI, 0.35-1.08) as the most predictive variables related to implanting embryos. Blastocyst morphology was not considered relevant in our model. The hierarchical tree model subdivided embryos into four categories, A-D, with lowering expected implantation potentials (from 47.3% for A to 14.2% for D). CONCLUSION(S): The analysis of warmed blastocysts by time-lapse imaging may provide objective quantitative markers for the blastocyst implantation potential. We propose a hierarchical model to classify vitrified/warmed blastocysts according to their implantation probability. The observed correlations and the proposed algorithm should be validated in a prospective trial to evaluate its efficacy.
引用
- Coello A, Meseguer M, Galán A, et al. Analysis of the morphological dynamics of blastocysts after vitrification/warming: defining new predictive variables of implantation. Fertil Steril. 2017. PMID: 28863936. doi:10.1016/j.fertnstert.2017.07.1157
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。