文献速递妇科

机器人辅助腹腔镜下膈肌子宫内膜异位症切除术的10个标准化步骤

Robotic Management of Diaphragmatic Endometriosis in 10 Steps.
PubMed 文献 · J Minim Invasive Gynecol · 2022-03-16

本视频展示了使用达芬奇机器人辅助标准化切除膈肌子宫内膜异位症的10个步骤,包括体位、穿刺孔布局、粘连分离、病灶切除、膈肌修补及排气等。研究为手术教育视频,来自三级转诊中心,描述了76例患者中术后第1天胸部X线未发现需要胸腔引流的严重胸膜炎。结论认为该标准化10步法可完整切除膈肌病灶且临床结局良好。

要点

  • 患者取左侧卧位并头低10°,建立3个8mm及1个10mm穿刺孔。
  • 小病灶在造成气胸前用20瓦低功率单极切除,全层病灶切除后立即出现右侧完全性气胸。
  • 缝合最后一针前抽尽胸腔内CO2使膈肌凹陷形成,因此无需放置胸腔引流。

核心结论

  • 机器人辅助腹腔镜下切除累及膈肌的深部子宫内膜异位症是一种标准化的10步手术,可完整切除膈肌病灶并获得良好临床结局。

研究设计与样本

  • 手术教育视频,经当地机构审查委员会确认符合发表伦理标准并获得患者知情同意,来自三级转诊中心。

主要发现

  • 手术时间30分钟至1小时。
  • 至今76例患者中,术后第1天常规胸部X线未发现需要胸腔引流的术后严重胸膜炎。
  • 第6步全层切除贯穿性病灶或孔洞后立即出现右侧完全性气胸。

关键数值与推荐

  • 患者取左侧卧位并头低10°。
  • 制作三个8mm切口:右锁骨中线放内镜、腋中线放双极钳、剑突下2cm放剪刀;脐上3cm作10mm助手穿刺孔。
  • 小病灶(无需全层切除)在造成气胸前先用20瓦低功率单极切除。
  • 第10步中,尽管缺乏高级别证据数据,本研究中心常规使用防粘连剂以减少术后粘连。

临床怎么用

  • 本研究中心常规在术后第1天行胸部X线检查。
  • 本研究中心常规使用防粘连剂以减少术后粘连,但原文指出缺乏高级别证据数据。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

OBJECTIVE: To present 10 standardized steps of the surgical management of diaphragmatic endometriosis using Da Vinci robotic assistance. DESIGN: Surgical education video. The local institutional review board confirmed that the video met ethical criteria required for publication. Patient consent was obtained. SETTING: Tertiary referral center. INTERVENTION: The film presents a standardized way of performing excision of diaphragmatic endometriosis using the following 10 steps: (1) The patient is placed in left lateral decubitus and 10° proclivity [1,2]. (2). Three 8-mm wide incisions are made, including on the right medio-clavicular line for the endoscope, on the medio-axillar line for the bipolar forceps, and 2 cm below the xiphoid appendix for the scissors. A 10-mm incision is made 3 cm above the umbilicus for the assistant trocar. (3) The procedure starts by an inspection of the right diaphragmatic surface; the falciform ligament is sectioned to allow exploration of the left diaphragm and supplementary mobilization of the liver. (4) Adhesions are completely sectioned, down to the hepato-phrenic cul de sac, tangentially to the liver surface. (5) Small lesions, which do not require full thickness excision, are first removed, before creating a pneumothorax, using a low monopolar setting at 20 watts [3]. (6) Full thickness excision of transfixing lesions or holes is carried out using monopolar scissors and results in an immediate complete right pneumothorax [2,4]. (7) The pleural cavity is inspected to identify disseminated lesions in the chest, located far from the diaphragm. (8) Repairing of the diaphragm is carried out by performing a unidirectional barbed suture. (9) Before performing the final knot, the laparoscopic suction irrigation canula is introduced into the chest cavity, and the CO2 used for inflation is fully aspirated, leading to the creation of the diaphragm concavity; the use of a chest drain is therefore not necessary. (10) Despite the lack of high-level of evidence data, we routinely use an antiadhesion agent, with an aim to reduce postoperative adhesions. Operative time varies from 30 min to 1 hour. Chest X-ray is routinely performed at postoperative day 1. To date, in 76 patients, X-ray did not reveal postoperative relevant pleurisy requiring chest drainage. CONCLUSIONS: The robotic-assisted laparoscopic excision of deep endometriosis involving the diaphragm is a standardized 10-step procedure that allows a complete removal of diaphragmatic lesions with good clinical outcomes.

来源:J Minim Invasive Gynecol,查看原文。版权归原作者所有。

引用

  1. Roman H, Dennis T, Grigoriadis G, et al. Robotic Management of Diaphragmatic Endometriosis in 10 Steps. J Minim Invasive Gynecol. 2022. PMID: 35304303. doi:10.1016/j.jmig.2022.03.005

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。